More than just a fancy name. TURNIGY nano-tech lithium polymer batteries are built with an LiCo nano-technology substrate complex greatly improving power transfer making the oxidation/reduction reaction more efficient, this helps electrons pass more freely from anode to cathode with less internal impedance. In short; less voltage sag and a higher discharge rate than a similar density lithium polymer (non nano-tech) battery. For those that love graphs, it means a straighter, longer curve. For pilots it spells stronger throttle punches and unreal straight-up performance. Excellent news for 3D pilots!
Unfortunately with other big brands; numbers, ratings and graphs can be fudged. Rest assured, TURNIGY nano-techs are the real deal, delivering unparalleled performance!
* The nano-core technology in lithium ion batteries is the application of nanometer conductive additives. 1) The nanometer conductive additives form ultrastrong electron-conducting networks in the electrodes which can increase electronic conductivity. 2) These additives create a superstrong ability for imbibition in the carrier liquid to supply more ion channels. This improves the ability of ion transmission and ion diffusion. Through improving electronic conductivity and ion transmission, the impedance is reduced and the polarization of high rate discharge decreases greatly. Advantages over traditional Lipo batteries; -Power density reaches 7.5 kw/kg. -Less Voltage sag during high rate discharge, giving more power under load. -Internal impedance can reach as low as 1.2mΩ compared to that of 3mΩ of a standard Lipoly. -Greater thermal control, pack usually doesnt exceed 60degC -Thickness swelling during heavy load doesnt exceed 5%, compared to 15% of a normal Lipoly during heavy load. -Higher capacity during heavy discharge. More than 90% at 100% C rate. -Fast charge capable, up to 15C on some batteries. -Longer Cycle Life, almost double that of standard lipoly technology.
I'd get the Turnigy MEGA 400Wx2 Battery Charger/Discharger (800W) and the Turnigy 1200W power supply. You can charge two of these packs simultaneously at more than 20 A each! Your charge time for both would be less than 15 minutes.
Hi Dan I use two of these batteries in my HPI Baja 5B Flux wired in serial massive power nearly uncontrollable with all the power and massive torque out performs all of my mates with gas powered Baja's I am getting approx 24 minute run times normal ground conditions about 18 minutes flat out non stop on the beach unbeatable performance on the beach with paddle tyres the Baja also runs great with two 3s 5000 mAh 65c-130c which is a lot more controllable and a bit easier on the pocket something to think about either way these batteries are perfect for your Baja 5B castle creations powered monster way to go buddy
What exenstion will I need to Plug the Turnigy nano-tech 5000mah 4S 65~130C Lipo Pack into my triton2eq charger. Then what extenstion from the battery to my Deans male Ultra adapter that goes to my Electronic Speed Control. I will need both.
A simple pair of 4mm bullet plugs will do just fine. For the esc side you will need a male plug on the red( ) wire and a female plug on the black (-) side. Same goes for your charger and in this case you can make a charging lead with 2 male 4mm bullets for the charger side and the aforementioned setup to match the battery.
The Plug per se is the HXT 4,00mm and is sold here at hobbyking too. I have started converting most of my electronics from Deans to this plug. Much better.
Recieved this thing today it came verry well balanced after charging i put it in a hexacopter with 6 ntm propdrive 140watt it flies great lots of power and runtime great lipo with true C rate will buy more when its available in the europe warehouse