Planes & Parts
Helicopters & Parts
Multi-Rotors & Parts
Cars & Parts
Boats & Parts
Bikes & Parts
Scale R/C Tanks
FPV & Telemetry
Batteries & Accessories
Chargers & Accessories
Robotics & DIY
Servos & Parts
Radios & Receivers
Gas/Glow Engines & parts
UBEC & Regulator
Hardware & accessories.
Clothing, Gift & Acc.
USA warehouse now open. Our USA warehouse is now open!
Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
26mm x 27mm , 40mm(with shaft) Weight: 39g (Diameter of shaft: kv1200) (not including connectors) 3mm Length of front shaft: 12mmLamination thickness: . 2mmMagnet type: 45SH Max performance Voltage: 2-3S Prop: APC7x4
For 300~500g airplane.
PRODUCT ID: T2627-1200
Max Current (A)
Max Voltage (V)
Shaft A (mm)
Length B (mm)
Diameter C (mm)
Can Length D (mm)
Total Length E (mm)
Update/Add my own data
1 points - 2/19/2013
1 points - 2/14/2013
What battery and speed I have to use the kit below:
Turnigy 2627 Brushless Outrunner 1200kv
It will depend on your type of setup, if it is a sport or a slow flyer. Although, you can use a varity of speed controlers 20-30Amp Speed controler or higher "depending", and a 2-3s battery.
Anybody know of a replacement shaft for this motor? My plane nose dived and the shaft neatly snapped (didnt bend!)
update: I now have 3 of these with a snapped shaft, time to change to a motor with replacement parts until I learn how to fly!
get the AXN cloud fly
you will need aerobatic skill to to bent the shaft of it's motor
Does this motor fit well in the Kinetic ?
96 points - 2/20/2012
How much thrust on 3s with a 6x5e or 6x4e or 6x3e?
can this lift the balsa extra 300?
yes no problem even with a 2s lipo
Hi would this motor work with the kinetic whitch uses a 8x5 prop? If not what motor would.
Ive been flying a 7X6 and have no problems Heat wise not able to do any diagnostics but I use 20 amp ESC and have had no trouble comes down nice and cool.
Ho do I mount this motor? If I have a Cherokee, Can I mount it on the firewall?
yip. you take the looking mounting bracket with the 8 holes . first fix it to the motor with the 4 countersunk screws then to the fire wall
BEST ANSWER CREDIT AWARDED
Yes, you can mount it on the firewall with the supplied X plate.
The Shaft ise 3.0 mm and not reversible...
Is the shaft 3.0 or 3.17mm?
the motor shaft is well 3.0
Can the prop shaft be changed so the mtr is mounted from the back?
I have actually used this motor and reversd the shaft. The only issue is you can't put the circlip on because there isn't a groove. Either cut a new one or put one of those rings with the grub screws in it on the shaft. (HK's Landing gear wheel stopper)
Yes, I have done that with all my red & blue motors. Works great.