ZIPPY Flightmax 1800mAh 3S1P 20C

 Lance 11 points

Charge * 1.8 A to get the best life out of the battery.

 Sethe 44 points

yes. it will work

 Aaron 17 points

Yes however I would recommend a 2200mAh as they last longer

 Glenn 13 points

Not sure if it will fit but these are the dimensions www.link

 Glenn 13 points

I hate it when HK deletes my links!! Yes it should fit in the erevo. It is 103mm long, 20.46mm high, and 31.48mm deep. Hope this helps.

 wellmanite 183 points

1.8A if it says max charge rate of 1c on the back. If it says max charge rate of 2c then you can charge it up to 3.6 amps.

 Glenn 13 points

Normally it says on the back. But This battery is 20c so 2c is the max you can safely charge it at. What this means is that 1c is 1.8amps. For any batterie the best rate to charge it at is 10 percent of the mah. Please credit me if that helps.

 neoh 5 points

What is 10 % of the mah 1800 ×*10%=180 ???

 Glenn 13 points

Ya know I was wasn't sure how to say it here is what I meant. If you have a 1000mah battery 1c rating would be 1amp. On this battery 1800mah 1c would be 1.8 amp. So I guess it would be divide it by 1000. Sorry about my previous note. So I charge mine up to 3.6 amps.

 Jujake 93 points

it has to support Lipo batteries. Has a balancer. Supports at least up to 3s Lipo (3-cell lipos).

 skyshooter 11 points

Yes, ofcourse.

 Benelly 3 points

www.link charger can work with this battery.

 Glenn 13 points

The turnigy accucell 8 and the turnigy accucel 6 are great chargers.

 Komarek 33 points

It is a X T60 discharge plug

 Greenfuelboy 162 points

Hi, Like the other guy said it is a Turnigy XT60 plug. Just cut it off and solder on your favorite plug. I use Deans plugs on mine. This battery has the same balance plug as an E-Flite battery.

 1ndyt1n 2 points

i had mine cut and soldered with a traxxas connector, they work fine

 Marc Lester 2 points

XT60 plug my friend. you can change it to any plug you need, you just need to cut it off and replace it with the one you prefer..

 jos111995 5 points

XT60, but I like the T-connector more.

 Speed Boy 14 points

I have two of these batteries and both of them has XT60 connector that hard to connect to any male connectors i have. Just re soldered them to another XT60 connectors bought from hobbyking (genuine one). So, now it much better! On my Cessna 182/1200mm/860gr/NTM Prop Drive Series 28-26A 1200kv 250w/10x4.7SF prop - i have 9-10 minutes flight until cutoff. Good batteries.

 H-KING_SCOTT 5155 points

Have you checked the dimensions?
If it fits, it will work. Just make sure you also get the adapter plug (also sold here).

 1ndyt1n 2 points

yup, it works on the mini e-revo, you just have to change to a smaller gear so the motor wont overheat. you can consult the manual for the proper gear ratio to be used

 jos111995 5 points

Yes, i't works in an mini e-revo.

 j-tet 7 points

tight fit but should work, cut a lil notch in the battery door for wires. if dimensions are off call customer service.

 Greenfuelboy 162 points

Hi, it means cells in parallel. If it says 2p than it has more than one per cell. So a 3cell lipo, 3slp has only three cells in it. The amount for 3 cell 2p battery is different. I do not like the 2p batteries because they are in series, and could burn inside if you over amp them. You would not even know if it happens, and it will drain the battery too low on the damaged cell and ruin it.

 787-8 19 points

3 serie 1 parallel.

p is not important.

 zappulmo 23 points

3s1P means

3 battery cells in series 1 Parralel.

basiclay in this case, the 1 P means nothing as you have 3 LiPO cells connected in series to give you the required voltage

hope this helps

 SITAS 13 points

Recomend Turnygy Accucell 6.

 Gr_Al 5 points

It mean 3 successively 1 parallel i.e. 11,1V

 Kaldek 9 points

3S1P means there are three cells in Series (hence the "S"), the 1P means that they are not connected in parallel. Remember, connecting batteries in Series increases the voltage. Connecting batteries in Parallel increases the capacity (mAh) but not the voltage. Very few batteries sold are 2P. Connecting batteries in parallel is usually something *you* would do to increase the flight time on a model without increasing the voltage. Remember, more voltage makes the motor spin faster, but more a

 Huibert 5 points

3S1P means 3 cells together in serial conected what gives 11.1 volt. When a pack says 3S2P there are 6 cells,2x 3cells serial, what also gives 11.1 volt. This was done because the first lipo's did't have high capacitie.

 WickedDragon 10 points

Actually it*s the 3S1P part that's important. This applies to all lipo batteries. 3S1P = 3 cells in series and 1 cell in parallel. The battery pack consists of a total of 3 1800mAh cells. Each cell in a lipo pack is 3.7 volts In this case we have 3 x 3.7 volts... that's where the 11.1 volts comes from. Again, each cell is rated at 1800mAh. For instance if your looking at a 4s2p 3000mAh pack..... You would have a total of 8 3.7 volt 1500mAh cells in the pack* with 4 parallel pairs in series. I

 ishady 340 points

YES, the battery come with that yellow connector called XT60 male. Thanks. -ishady-

 Brett 232 points

absolutely, they come with a female Male XT60 Connector. You can buy the Male XT60 connectors (5pcs/bag) from the Plugs section.

 Dr.LuckyLuke 317 points

Yes, they come exactly as it is on image.

 paulsouthport 60 points

Yes, XT60 connectors are attached.

 Napstr 686 points

Yep that is the new Hobbyking Standard - The XT 60 seem like very good connectors

 Cador 13 points

Yes its coming with yallow connectors

 healba 406 points

Yes, they come with the only yellow connector welded to the battery, so you will need to buy more for your Esc.

 MrHmmm 63 points

Yes they do, but if you want to put some other connector on the leads... just clip them off (one at a time) and resolder an other connector to the wires. There is enough wire for some clipping.

 Sidewinder1 5 points

Generally, what is pictured is the connector that is on the battery in question. Above looks to me to be an XT-60. You can always remove and install a connector of your choice.

 quesnes 154 points

Yes, the XT60 connector comes with it

 atunguyd 16 points

yes connectors are included as in the picture

 Giles 5 points

Yep anything other than the smallest LiPo's which come with the little red JST connectors and the largest which come with red bullet connectors will come with the yellow XT60 connectors

 simon 31 points

think I read somewhere that there the new standard on all zippy,s, a great connector I just recieved 3 new zippy 2100mah 3s 35c they came with them way better than deans I use, Simon

 Waltudes 14 points

yes, come with XT60 conectors

 traxxasman314 4 points

yes they do come with yellow connectors on the batteries.

 787-8 19 points

Yes come with yellow connector(xt-60)

 MarekM 7 points

Yest, they do.

 Greenfuelboy 162 points

Hi, Yes they come with the yellow battery connector.

 Gr_Al 5 points

Discharge plug: XT60 XT60 - yellow conectors

 kekelala 307 points

Yes. They do. Thx!

 WickedDragon 10 points

Some do, some don't. Generally if it's noted in the description, they're included.

 Majster 74 points

Hello
Can you tell me what is the real length of this batteries? (without wires)

 moller123456 648 points

i might have found the problem-.- im not the best at soldering:P might give a update tomorrow:)

 Henrik 75 points

nope mine works all fine in traxxas slash vxl and xray m18 and i charge them with a hyperion charger with out any problems

 nitro 158 points

i found out that the car is rough and it destroys the connections but you can fix it but its risky good luck trying to fix it

 Potts 19 points

Faulty

 Destructor 162 points

I have had this problem with a few batteries in my planes that draw high amperage. It heats up the conections on the board attached to the top of the battery and melts the solder that makes the conection. If you cut the wrapper at the top where the wire leads come out you can get to the board and you will see where the solder seperated. You can put a little peice of heavy wire in there or I just re solder it and leave it on there thick! then tape it back up. I lost 2 EDF planes to this problem so now I open every battery I buy and look it over. Out of the 79 batteries I have about 11 of them had this problem. All turnagy batts and all diffrent Milliamps.

 Destructor 162 points

Sorry I meant all zippy batterys. My turnagy ones did it as well.

 moller123456 648 points

Hey kan se du er dansker.
S lnge det er en lader der kan lade op til 3celler eller over, s burde det virke:)

 nitro 158 points

i dont know but i use a b6 charger they work great and fast charging

 Potts 19 points

Yes, if you can select the current

 moller123456 648 points

4mm gold

 Henrik 75 points

mine came with deans plugs

 traxxasman314 4 points

it is a ec3. if you don't use this type of plug you will have to cut it off and solder on your own plug.

 Benelly 3 points

nice with dean..

 Rob 13 points

Talked to cust. service. this LiPo, has no connector on discharge side.

 Henrik 75 points

i uses the standard jst plug system that are used on all the hobbycity lipos i have recieved

 Julio Cezar 1 points

no... only the charger and the plug used in motor

 traxxasman314 4 points

yes it comes with an xt60 plug.

 787-8 19 points

YES HAVE XT-60

 Henrik 75 points

i use this pack in my xray m18 with brushless setup and in my traxxas slash 1/16 vxl and it works fine

 Dee Dee 114 points

hello hobby king...do you have 15C of this kind of item?

 Julio Cezar 1 points

Parabns pela compra. Quero fazer o mesmo! Dura bem?

 alex.g 110 points

***********zippybattery****/ - but it doesn't work :(
Also looking for usage manual

 Miles-away 510 points

No, these Lipos must not be charged with more than 1C. They will be damaged if you do so.

 moller123456 648 points

It says it can be charged with 2C

 Julio Cezar 1 points

try ****flightmax****

 traxxasman314 4 points

they can be charged at 2c. thats where i charge mine at.