USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
i intend to use this on a hexTronik 16gram Brushless Outrunner 1700kv (PRODUCT ID: HXM2211-1700) and wonder how best to adapt the mounting as the as the motor shaft is a tiny bit small for the hole... is it possible to fit heatshrink as a workable "fattener" for the shaft ? are there other adapters to increase the diameter ?
I was thinking the exact same thing - but having tried doing this with other shafts/miss-matched props -n general have found that clevis heatshrink eventually the pull of the prop pulls the heatshrink off the shaft.
Hi I had a nose landing on my kinetic 800 and brop one of the props. I know they do replactmints here but its on back order on was wondering if I could use this instead.It sais on the props it sais 8*4 thank you
I'm looking for a folding prop spinner. I have 8x5 blades with a turnigy c3536-1600 motor mounted at the back of my wing. Is this product fine for me ?
thanks
Hello Romain,
go and widen the bore with a drillmachine.
Good luck
Reg. Martin
Customer Reviews
Overall Rating
Mike Roberts
likes
Value
UNRATED
Quality
UNRATED
7 thumbs up!
Hub is really nice. Would be even better if it would take a 3mm shaft! Note only 2-2.3mm and probably not enough meat to bore out. One blade had miss-aligned hole - hence 4stars. takes blades with 6mm wide holder and 2mm hole - hence fitted Graupner blades - works great. Hub dia is 32mm and hence fits the 'Pretty' a treat. Mike
2 comments. Reply..
Overall Rating
altidsulten
likes
Value
UNRATED
Quality
UNRATED
4 thumbs up!
One of the blades cracked durring a test-run, resulting in a destroyed model and motor. The hub itself shows no signs of damage. Use Aeronaut/Graupner blades only and throw away these supplied! The was no signs of damage on the blades before the test-run.
No comments. Reply..
Overall Rating
William Newson
likes
Value
UNRATED
Quality
UNRATED
3 thumbs up!
Although the blades supplied are slightly less modern looking than shown, with rounded tips, they are nevertheless very effective. Alternative bore sized shafts ought to be provided at reasonable cost thus increasing the application for many more motors. Being lucky enough to have a lathe, I have successfully bored mine out to 3mm (maximum). The hubs are cheap enough even if you replace the blades with Aeronaut/Graupner etc.
No comments. Reply..
Overall Rating
Jerry Dunn
likes
Value
UNRATED
Quality
UNRATED
1 thumbs up!
Solid construction, built to last. Nice chrome spinner. Prop blades are sturdy.
No comments. Reply..
Overall Rating
Danman
12 likes
Value
UNRATED
Quality
UNRATED
1 thumbs up!
That thing works great on a multiplex fox with the hextronik 16 gram outrunner on 2s 360 mah.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg){kind=small}
