Turnigy TrackStar 1/10th Scale 60A Car ESC Version 2 (USA Warehouse)
The Turnigy TrackStar 1/10th scale 60amp car ESC is the latest addition to Hobby Kings Car ESC range.
Using a Fast Silicon Labs MCU and high quality On-Semiconductor MOSFETs the TrackStar 60A ESC sets a new standard in high quality yet affordable car ESCs. With Intelligent MCU logic the TrackStar series ESCs allow extremely precise start up control and positioning feed back from the motor. This translates in to very smooth start up and acceleration.
The Turnigy TrackStar 60A ESC also boasts a host of programing options not usually found in a 1/10th scale ESC at this price and can be programmed with ease via the Turnigy TrackStar programing card (sold separately) The Turnigy TrackStar 150A ESC also included 3 x 10AWG Motor wires and 2 x 10AWG power input wires.
The Turnigy TrackStar 60amp ESC comes with an XT-60 plug and 3.5mm Bullet plugs pre-installed so you can install it in your car with without needing to do any soldering.
Specification: Cont. Current: 60A Burst Current: 90A Car Size: 1/10th Battery: 2-3 Cell Lipo BEC: 5V / 2A Output Motor Type: Sensorless Brushless Size: 51.6 x 30 x 27.4mm Weight: 78g Battery Plug: XT-60 On/Off Switch: Yes Reverse: Yes Thermal Overload Protection: Yes Motor Terminals: 3.5mm bullet
Programming Options (Via Optional programming card) Brake/Reverse type Brake Amount Voltage Cut off Drag Brake Reverse Power Start Power Throttle Dead Band
typo in description says its a 150a not a 60a in the line where it tells motor and battery wire awg. Paragraph below
The Turnigy TrackStar 60A ESC also boasts a host of programing options not usually found in a 1/10th scale ESC at this price and can be programmed with ease via the Turnigy TrackStar programing card (sold separately) The Turnigy TrackStar *** 150a *** ESC also included 3 x 10AWG Motor wires and 2 x 10AWG power input wires.
I have 5 of these esc All work great. I run the with a traxxas velinion 3500kv motor on 3 of them and turnigy 4000 on the other 2. No problems yet been 2 years. It keeps up with my traxxas esc too. You cant beat it for the price. I did burn one out but i over heated it with way too high gearing. Even the reverse still worked i blew up forward only. I would recomend it.
I'm Interested in buying this ESC, but i'm concerned about the abnormally low burst rating. Has anyone had trouble with this thing frying? The trackstar 25A ESC has a 90a burst rating. The HobbyKing 35A ESC (Xcar) has a 190a burst rating. The Turnigy 35A ESC has a 190a burst rating also. Yet this 60A ESC is only good to 90a? What gives?
I have this esc. I got it last month. I am running it in a slash 2wd with a hobbywing 4000k motor and so far its running good. I recommend getting the Trackstar programming card if you decide to get this esc. For the price its a good esc. Temps have been low on mine as well.
Chances are the burst current rating on this ESC is realistic and the burst current rating on the other ESCs that you mentioned are BS. IMO, you shouldn't really be choosing an ESC based on it's burst current rating anyway. The ESCs continuous current rating should be equal to or greater than the max. amps required by your motor.
I had my doubts about this esc, My son was running a hpi flux and the motor esc and motor failed. I replaced it with this esc and the Trackstar 1/10 9T 4370KV Brushless. Wow was i impurest, i blows the $200 hpi set up we had in to the ground.
No blinky mode as it doesn't have any led's. Personally I don't really like the "feel" of the esc. By that I mean it feels sluggish (no bottom end snap)and not nearly the top end as compared to the 100amp hk esc. I have played with all the punch setting and timing also and im not overloading it.
Lars**-Blinky refers to spec zero ESC timing. ESC typically has a blinking LED to indicate it is in the spec no boost mode.
hey wassup people ps9/jon here i just got this in mail from usa ware house and im gonna warn u now esc wont work unless you properly set the throttle range 1st!!!! and then im warning you for after you do that dont stand behind the rc n full throttle it with out body Armour and goggles..... trust me i know i did it and pelted my self with large rocks from rear of the 2wd sct we got n the mud flaps didnt stop any thing... im not gonna lie i had the sct for 5 days put that esc in it n guy came to buy a slash but wanted the sct after seeing it run with stock motor... last warning traxxas the saying "fastest name in rc " those days are numbered n its in double digits!!!! i promise, ok be safe have fun
1 comment. Reply..
For the money so far I am happy with this esc. I already had the program card and it is really easy to use with this esc. ok so far I have only ran this esc in a mini e erevo with the stock 380 motor but even on medium settings the esc puts out more than enough power to match the stock velineon esc. I was still able to do back-flips and wheelies on command and the tires still ballooned and rubbed the body when running a 3s battery. The aluminum case is also very handy as i flipped this thing plenty of times with the fan upside down in dirt and it's still works like new. It runs nice and cool on 2s and just a little warm on 3s. so you can probably go up in teeth if you're putting it in a merv. The only reason I didn't give it 5 stars is because the burst amps are too low for this esc compared to others in its price range on hobbyking. all the xcar esc's have burst ratings above 120a this thing doesn't even break 90a. the old version of this esc used to have a burst of 160a with only 90a burst it really limits what you can run this esc in. i think it would probably do fine in a 2wd 1/10 off road setting, but 4wd offroad would most likely imo fry the thing. and that really sucks for an esc that's labeled 1/10th scale. That being said I would highly recommend this esc for any application under 1/10th scale. id be cautious about using it in extreme 1/10 2wd offroad situations and I