USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
The highest SPEC HK Heli, the CMT is all metal, all carbon and allll good! You can't upgrade this bad boy, it's already upgraded to the maximum! Much bigger than it's smaller 450 brother, the 500CMT is an exciting helicopter to see in action and even more exciting to fly. It's 2024 alloy head ensures hard core 3D pilots wont be dissapointed in the performance and the beautifully painted cowl and Titanium anodized components make this a visually stunning helicopter with performance to back it up! Carbon Fiber main frame, CF horizontal & vertical fins also full metal tail unit makes this heli perfect for Pro's! All parts are 100% compatible with T-Rex 500 Included are main and tail blades & Carbon Fiber boom supports. Click here for parts and upgrades.
We guarantee you wont find a better priced heli of this quality anywhere!
Features. Light weight design provides awesome flight performance and extreme 3D capability. Rotor head/tail with thrust bearings. Direct-to-swash CCPM linkage. Center of gravity of battery tray designed close to the rotor head. High efficiency Torque-Tube driven metal tail. Fully driven tail auto rotation system. Tail servo boom mount. Carbon Fibre Main Frame and boom support rods.
Specification. Length: 840mm Height: 310mm Main rotor diameter: 970mm Tail rotor diameter: 200mm Motor pinion gear: 13T Main drive gear: 162T Tail drive gear: 31T Drive gear ratio: 1:12.46:4.68 Weight(without power system): 1370g Flying weight: Approx 1700g
Required items. Brushless Outrunner Motor Servos : See linked items below. Radio Gear : Gyro/Rx ESC : 80A or greater. Battery: 2 x 2200mAh 3S 20C or greater.
Well presented kit, all built parts are lubricated and most locked. Found a the mixers had both washers inboard rather either side of bearing but then the screws needed locking, so had to come apart.
Have invested in a set of Align body screws and washers as I found some of mine with damaged heads.
(Frame Hardware H50048-1) . Purchased from Align T-Rex .co.uk
The Tail boom inboard mount was well lubricated , the align variant has two separate bearings mounted in the casing , HK version has bearings inside steel tube .
Found a great Build sequence:
www.link
Model has proved to be a great value way into 500’s and all the spares from Trex 500ESP appear to fit, should require some obscure replacements.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
