USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
The North American Aviation T-6 Texan was a single-engine advanced trainer aircraft used to train pilots of the United States Army Air Forces, United States Navy, Royal Air Force and other air forces of the British Commonwealth during World War II and into the 1950s. The HobbyKing AT-6 is a very neatly designed EPOparkflyer. This Plug-n-Fly R/C plane comes with a brushlessoutrunner, ESC and servos all pre-installed. All you need is a 2S battery and receiver. Build time is around 15 minutes and does not require glue. The tough EPO construction keeps the model bouncing back for more and the strong 2607 outrunner motor provides plenty of power on as little as a 1,000mAh 2S LiPo.
So I finally made my maiden flight,was kinda windy but handled it quite well.Broke a prop on the second landing,have flown a couple more times sense.Are there any GWS props that can be recommended,would the 7x6 slow fly prop work on this plane??
So first flight was a no go,my elevator servo is freaking out and wont respond properly.I have a bunch of brand new HiTec HS55 micro servos from a previus plane build.Will swap it out and try again.
so doing more investigation on this site,I have found out that the point to measure CG is the 2 circles on top of the wing next to the fusaloge with the battery stuffed all the way in
Trevor there is a red and silver one available at the International Warehouse PRODUCT ID: HKAT6-C
HobbyKing AT-6 Brushless EPO Plug-n-Fly. I hope this helps.
Customer Reviews
There are currently no reviews for this product.
Be the first to review it by clicking the link above!
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg)
.jpg&width=48)
.jpg)
.jpg)
Want one 
