USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Have four of these servos, all have a ton of slop in the bearing.
No comments. Reply..
Overall Rating
underthetire
397 likes
Value
Quality
Like it?
Well, since I didn't want to wait for my normal servos, I ordered 4 of these. They seem to be fine. A little noisy but not terrible, normal for a digital I think. Don't notice any heat, and they seem to center ok. Time will tell if they hold up, but so far so good.
No comments. Reply..
Overall Rating
underthetire
397 likes
Value
Quality
Like it?
Ok, ignore my other review! Had one not center at all, it was all over the place. Figured i'd take it apart, for 4 bucks i didn't care. What i found out was well, scary. The pot is held in by the circuit board. You say, how is that bad? Well the circuit board is small, so they put shrink wrap over it, stuffed it long ways in the servo, and clamped the back on the servo. So, the only thing holding the pot on is compressed shrink tubing. If the board shifts, the pot pops right out. Easy fix really, but think i'll keep ordering the TGY9MG's.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg)
.jpg&width=48)
.jpg&width=48)
.jpg){kind=small}
