USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Turnigy® TRUST SBEC ESCs have a very flexible and broadly capable MCU, able to run all types of brushless motors. The large heatsink and simple PCB layout make heat dissapation consistant, enabling the ESC to be run at its limit, without failure. The ESC is program-card and transmitter programmable with clear and easy to understand instructions included. Default factory settings are; Brake: off Battery: LiPo Auto Detect Low Voltage: 3.2v (power down motor)
Spec. Max Motor Current: 55A Max BEC Current: 3A BEC Voltage: 5.5v (Switching) LiPo: 2~6S NiMH:5~16cells Weight: 53grams
you will have trouble fitting it in side the frame. It will just squeeze in width wise bu it is over 80mm long so it will not fit under the battery tray unless you do some modification so that it can poke out the front.
I have a 450 Helli, this normally runs a 40a ESC,is it better to go up in amps or should I stick to what I have, I have noticed the last coulpe of flights a stutter or quick break up of power,if I dont do somthing I am sure it will lead to a crash ** Thanks
sporty if you have to replace ESC then a bit bigger is good BUT remember bigger is heavier. Are you sure it is the ESC not battery or motor. The only way to know is to replace one or the other. ESC is cheaper than a motor. I think you have many batteries. Good luck. I hope this helps.
I have been using the Turnigy AE-45A for 6 months now and ran 2 different motors on it. I think it's the best ESC for 450, it has a wide range of programming and it is only warm after flights. Stick programming is extremely easy and the instructions are accurate. Also the soft start is so smooth!
I have to say that sporty may be right. I have had this ESC for a couple of months with no problem. However now, it seems to cut off power to the motor intermittently. Don't know if I should get another brand/model. Anyone?
Yes it was my RCX 40amp ESC starting to fail, it was just like a stutter in power! I have changed it for the Turnigy Plush 40amp, very nice unit, So I would recomend changimg the speed control before you crash, dont wait!!
Thanks for such a quick reply. TURNIGY TRUST 55A SBEC Brushless Speed Controller is the one that cuts off power. I wasn't sure about the brand. Thanks again. I will buy another ESC.
Customer Reviews
Overall Rating
Nigha
40 likes
Value
Quality
Like it?
Created surging at full throttle, over-heated the batt, melted the ESC heat shrink and surrounding foam as well as shuddering starts no matter which way the card programmed it. After all the glowing reports here clearly I pulled a short straw ! Its got a new home now, at the bottom of the TRASH CAN !
Running this with a Turnigy L3010B-1300 Brushless Motor (420w) and Turnigy nano-tech 1300mAh 3S 45~90C Lipo Pack in my Hobbyking Yak 55 3D 1096mm EPP with excellent results.
Great ESC, reliable and no overheating problems. It is somewhat large so I wouldn't recomend for electric gliders, but should fit in just about everything else OK. Also comes with full instruction manual, though I would recomend the turnigy trust programing card.
No comments. Reply..
Overall Rating
Nivit
2 likes
Value
Quality
Like it?
This is a solid and reliable ESC. Using it in my HK Extra 260 balsa with NTM 3548 900kv, 12x6 props and 2200 mAh 4s. Have flown 60 flights now without any problems.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg&width=48)
.jpg){kind=small}
