USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Can i use this servos with 5,9v because my PowerBox Sensor can only 5,9v use for servos and rx. But when i can use this servo with 5,9v what for ncm i have then?
i use mine in a rock crawler giving it 7.4 volts using a cc bec unit to power it at 6volts it has robust torque but turns a little slower.awsome ser vo especialy fore cars or trucks 6 volts should be ok you can upgrade to 7volts if you realy want
Un centrado muy bueno y mucho par a 6v. Lo uso en un crawler bully comp. y solo lo e usado 1 vez durante 1 hora y perfecto. Ya os contare como va dentro de un tiempo para una opinión mas estricta.
Yes it will run on 4.8v. But the torque output will be lower and the speed will also be reduced. Torque and speed would roughly be 15kg & .21sec respectively.
I have ordered 6 of these for my 50cc yak,to be honest i am not confident,i am not sure they will take unregulated 2c lipos 8.5v ? isn't it too much ?
I have seen 2 elev 1214 unregulated on a friends 85cc extra which stopped working during pre flight check up.
Hi sudi9, no, it's not too much, this servo can be used in 7,4V "mode" that means 2S lipos, and of course when the lipo is charged the HV-servos are designed to work up to 8.4V, so no problem. But for me, with a big plane, it's better to have a powerbox and not an unregulated tension.
Es uno de los mejores servos que conozco, es rapidísimo, preciso.
Es una gran compra HD esta vez ha echo uno de mos mejores servos del mercado a un buen precio.
Lo tengo instalado en un katana 50cc
2 comments. Reply..
Overall Rating
Henrik
39 likes
Value
Quality
Like it?
Top quality servo for the price,have tested i twice in my highly upgradet axial wraith with tekin sc4 x 550 5,5 t motor and it does the job just as well as the futaba bls 352 i used in it before,this servo actually has less play in the gears compared to the bls 352 but maybe slightly slower but what the heck the other servo is 100-150 $
The output axel has a 25 spline axle or futaba style,hobbyking sells this horn for www.link downside is the kinky purple colour ;-)
Good servos, was a bit unlucky as out of 7 ordered one was dead and 3 were missing grommets. The good ones are nice and powerful and silent when centred. All 7 in a 50cc gold wing pitts running 7v .
Excelent servo for the price hav installed in to baja 5B with front hydrolic disk brakes pulls much better for front brakes than a 15kg servo
1 comment. Reply..
Overall Rating
visagie
10 likes
Value
Quality
Like it?
I received mine today and it's not working at all. 36$ lost. Don't want to send it back. will cost maybe more than a other one. I hope HK will increase the quality control.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg)
.jpg&width=48)
.jpg&width=48)
.jpg){kind=small}
