Click here to view more products in the DE warehouse.
Item also available from our (International) warehouse view now.
We cannot ship to German Packstation addresses.
Wichtige Hinweise zum Umweltschutz
All products sold within Germany are CE Certified and comply fully with European/German environmental regulations!
I do not get the startup musical sound, it only starts with the programming single, dual and triple beeps for programming the three available options (LiPo, NiXX, Brake on/off).
There seems to be no way to set the throttle range, and when I try to engage the throttle, the motor just shudders and beeps horribly, like an error sound (not quite the same beep as for the programming). Then, if I go to full throttle again, it just re-enters the programming beeping section, even though I have accepted LiPo as per the first programming choice. Starting up normally with throttle off sometimes gives the three beeps to confirm 3S LiPo, but without the musical startup sound.
I use a Turnigy 9XR FrSKy DJT Tx and D8R-II plus Rx. ESC is plugged into channel one, which is confirmed to be working, and all the servos are working fine too.
Any idea's would be appreciated!
Hi Antonin! Here is a very basic manual for this ESC:
Super Simple 20A Programming Guide
there are three setups.
put throttle stick to max power and turn on the battery
first –* Lipo *peep* - *short pause* - *peep*
second –* Ni-XX *peep*peep* - *short pause* - *peep*peep*
third –* Brake *peep*peep*peep* - *short pause* - *peep*peep*peep*
when you hear the bibs by the second time, just put the throttle stick to idle on the
repeat the steps to all the configurations.
Please credit answers :D