Yes it runs my CS 12 blade fan on 6S at 83A stabilized (90 initially). This is one strong motor!
The only modification I would recommend is use the 36mm style cooling fins to keep temperatures in check.
hello, the engine that class and 540? distance measures that screws engine (engine mounting screw spacing distance between shaft) thanks google traslator ciao,il motore che classe e 540? che misure interasse viti di fissaggio motore(interasse vite fissaggio motore con interasse shaft) grazie
Foto misure distanza fori fissaggio motore google traslator Photo measures distance engine mounting holes
No comments. Reply..
Great motor for the new Changesun 90mm 12 blade fan! The case needs some sanding to fit the 39mm shroud which was done in minutes on my belt sander. On 6S this motor draws 83A/1900watts stabilized. I added HK cooling fins (made for 36mm motors but fit this as well) and the motor temps were very reasonable at about 150F max after extended running at WOT.
I did notice the large allen screws holding the end cap did not have any locktite so some was added to each screw. The small screws on the other end were secured properly and no locktite was needed.
4 comments. Reply..
i got this motor yesterday in the mail ..""""" packaging is not flash """"" ignore that """,,, hooked it up to the 120 HK ESC i also got .... used the HK 150 car program card to adjust a few settings then out for a test in my Himoto buggy on 4s 5000... let me say this is the best set up i have ever had in this buggy" ITS FAST " .... although its 1500 kv it still gets a bit hot when bashed for 10 mins with motor timing on high .. so i put that back at the default setting ....... 5 crowns all round .. thanks HK