Turnigy 5000mAh 3S 30C Lipo Pack (USA Warehouse)

 Rigg. 3 points

Sorry no these are to big for the stock battery trays without modification. Even though they are soft packs they are longer and thicker than a standard hard pack 2SLIPO. These are BIG Batteries.

 SKiN666 11 points

these packs fit perfectly in the battery trays of the e-revo. the issue is the big wires on the packs. the battery door needs to be modded so the wires can exit. OR... you could mod the vents... i cut mine so i could run my EC5 connector and wires through the vent. works perfectly!!

 Dogbreath 5 points

Use this battery in my SCX10 with a 35T motor and am getting over 4 1/2 hours run time....Great battery, big fuel tank for a scale truck!

 jim 3 points

yes they can my co worker uses these and also the 3s nanotechs, but yes there tight. im waiting for my erevo. i got a pair on order so they better. i already bought the wrong batteries once the short square hard case 3s 5000s oh well theyll fit it the rustlers i got.

 kevo450 17 points

that tells you how the pack is built 3s1p means 3 cells in series as 1 parallel pack 3s2p means 6 cells total as 2 parallel packs of 3 series cells each.

 Justin James Franz 6 points

its just how the cells are. 2 in series and none in parrell

 Markus 2 points

that means one paralell.

 Brandon 1 points

3s1p stands for 3cells in series and they are in parallel. If there were more cells in parallel it would double the "mah" rating. So a 3s2p would be a 3cell in series in each series but 2 in parallel. So if you had a 3s2p 2000mah lipo it would actually be a 3s(11.1volt) battery with a 4000mah capacity.

 Eric 2 points

"s" means series, and "p" means parallel. For example, the pack you are talking about has three cells in series (11.1v) and one in parallel. That means there are only three cells in the pack wired in series, and each with a capacity of 5000mah.

 ANDY 7 points

not without modification. the 3600mAh packs fit very easily though!

 Brian 2 points

no, the battery will be to small for it

 billy 2 points

no it will not fit because of the exit position of the power wires, the wires exit out the side of the corner rather than straight out the front of the battery or uo out of the battery

 Markus 2 points

no you need to modify the battery tray. either get the expanded battery hold down or go with velcro straps.

 SKiN666 11 points

don't let modifications needed scare you. very easy. i bought two of these packs, and LOVE them in my stampede. the sides of the battery need to be dremeled a little wider. as for how much i am unsure but its just trial and error... take a little off and check for fitment. also i did not want to cut out the back wall of the battery tray (too much weight in the rear as is) so i removed the front of the battery tray. up to the wall just before the rx. it is VERY clear what needs to dremeled