USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Mine just arrived in the mail. They are 55 mm end to end, and 50.5 mm from pin centre to pin centre. Tonight I will see if they fit the A2003T as well.
They do not fit the A2003T truggy. They are 4mm too long for the rear and 5mm too long for the front of the A2003T, so I will have to cut and sleeve them, or wait for spares to arrive. I'm a sad www.link
I don't think they will. The dogbones from the 110BS and A2003T are 75-76mm in length, and dogbones for the HPI Savage seem to be 123 mm long.
I have some 110BS dogbones on order, and will measure them precisely when I get them, this week, I hope.
Mine just arrived in the mail. They are 55 mm end to end, and 50.5 mm from pin centre to pin centre. Tonight I will see if they fit the A2003T as well.
These are quite small, but they do not need to be beefy for such a small buggy... good to have extras cause they tend to go missing when you snap an upright
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
