USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
3DSpinner for HP-50 / DLE55 / DA50 / JC51 (41x41x26mm) Silver A sexy, low weight, no fuss spinner for your gas engine! Many engines share the same bolt locations as the DL and DAs. So this cone will fit a large variety of motors.
So I have a dle55 and i'm wanting to buy this nose cone.....My question is, will I have to cut down that center shaft piece on my engine that the center hole of the prop slides onto? **** *Or can I bolt this nose cone right on as easy as 1..2..3 with no cutting?
Light durable and good looking. Fits in DA 50/60 and DL 50/55, DLA engines. Engine gained about 50 rpm due to a standard fiting and 95mm carbon spiner tested with magnetic ignition rpm counter. Not much but it's only the spiner.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg)
.jpg){kind=small}
.jpg){kind=small}
