USA warehouse now open. Our USA warehouse is now open!
Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
ASP S61A - Carb Assy
PRODUCT ID: S61A-S61801
Does this Carb Contain 2 Threaded mounting holes on side of carb ?
14mm is wrong.
15mm is correct,
This carburetor is 15mm.
2 points - 3/8/2014
I am sorry - wrong carb!
My submission 2/23/2014 might be wrong, I have an other
carb, not the one in this page. OD mentioned is wrong.
Sorry, sorry! Sad greetings from Sweden.
2 points - 2/23/2014
The O.D. of this carb is 13.99 mm. It fits directly into my old OPS Ursus 60 as well as many other engines. Greetings from Sweden.
14mm is wrong.
15mm is correct.
MARKOO IS CORRECT: I HAVE ONE IN MY HAND...IT IS 14.97 MM OR A 15MM HOLE
THIS MAY HELP YOU A LOT* THE ASP-108 CARB HAS THE SAME OD FOR MOUNTING. HOWEVER, IT HAS A LARGER INSIDE DIAMETER FOR MORE AIRFLOW THUS MORE POWER. I USE THE ASP-108 ON SEVERAL LARGE MOTORS THAT REALLY SUCK UP THE FUEL. GREAT CARB...Replaces the original ASP- 108 CARB that comes with the engine. Much better than the original.
IT WORKS GREAT ON THE ASP-61...INCREASED AIR FLOW.
is a good carb. I'm pleased.
I had to spend around the carb mechanic to remove 1mm. was very good.
Use this for my HP 61 motor
Easy to adjust, and realy good for the HP. Never stop in the air. (I had to take of 0,5 mm in a lathe machine, to make it fit in the HP 61) 5 stars
With this carb I replace original "Air Bleed" type on Magnum GP 65 SE. With original I have problems tunning the motor propperly and many "dead stick" landings.
ASP Twin needle is better, much easier to adjust low rpm`s and idle. Both carbs have 15mm throat so they easily to change...
.....click here to see all reviews