USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
hi will this fit 4x7mm flanged ball bearing? anyone done this? pls help guys i building twin cat and need to know this details as i like to have ballbearing stringer many thanks
Yes it will,but you will have to enlarge it to 7mm.It will have to be straight because thats only 1/2mm per side and only go the depth of the bearing as to keep it strong.Hope this helps.JK.
Yes it will fit but it will be a tight fit.You will have to be a experienced boat modeler to accomplish this but it will work.You will need to find a left lay 4mm flex cable so you have counter rotating props (hobbyking has the right lay 4mm flex shaft).If you look at the twin motor apparition you can see that they have both props turning the same way,it will work but if you counter rotate them(one right and one left)it will runn straight as an arrow and much better overall control.
Hears something that probably never heard of* when a cable shaft is to big for my setup, i sand cable shaft down with wetdry s/paper with cable or shaft in a drill. I wear gloves and takes TIME to do so till shaftis smooth when inserted into homemade strut and almost no play and have done this for many years i care to remember.
czesc jak ty zrobiles ze dales tam rade wlozyc lozysko 4x7mm czy moge prosic o pomoc jak to zrobic? p.dedys5*hotmail**** czy trzeba nawiercac??
dzieki za pomoc
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
