Please confirm your location:


  Item found in the following categories;
> Batteries & Accessories > Li-Poly (All brands)
> Batteries & Accessories > 25C Discharge
> Batteries & Accessories > Turnigy nano-tech

  RATED:

Turnigy nano-tech 5000mah 3S 25~50C Lipo Pack

Turnigy nano-tech 5000mah 3S 25~50C Lipo Pack

More than just a fancy name. TURNIGY nano-tech lithium polymer batteries are built with an LiCo  nano-technology substrate complex greatly improving power transfer making the oxidation/reduction reaction more efficient, this helps electrons pass more freely from anode to cathode with less internal impedance.
In short; less voltage sag and a higher discharge rate than a similar density lithium polymer (non nano-tech) battery.
For those that love graphs, it means a straighter, longer curve. For pilots it spells stronger throttle punches and unreal straight-up performance.
Excellent news for 3D pilots!
 
Unfortunately with other big brands; numbers, ratings and graphs can be fudged. Rest assured, TURNIGY nano-techs are the real deal, delivering unparalleled performance!

Spec.
Capacity: 5000mAh
Voltage: 3S1P / 3 Cell / 11.1V
Discharge: 25C Constant / 50C Burst
Weight: 403g (including wire, plug & case)
Dimensions: 169x48x25mm
Balance Plug: JST-XH
Discharge Plug: 4mm bullet-connector

 

 
*
The nano-core technology in lithium ion batteries is the application of nanometer conductive additives.
1) The nanometer conductive additives form ultrastrong electron-conducting networks in the electrodes which can increase electronic conductivity.
2) These additives create a superstrong ability for imbibition in the carrier liquid to supply more ion channels. This improves the ability of ion transmission and ion diffusion.
Through improving electronic conductivity and ion transmission, the impedance is reduced and the polarization of high rate discharge decreases greatly.
Advantages over traditional Lipo batteries.
Power density reaches 7.5 kw/kg.
Less Voltage sag during high rate discharge, giving more power under load.
Internal impedance can reach as low as 1.2mΩ compared to that of 3mΩ of a standard Lipoly.
Greater thermal control, pack usually doesnt exceed 60degC
Thickness swelling during heavy load doesnt exceed 5%, compared to 15% of a normal Lipoly during heavy load.
Higher capacity during heavy discharge. More than 90% at 100% C rate.
Fast charge capable, up to 15C on some batteries.
Longer Cycle Life, almost double that of standard lipoly technology.


PRODUCT ID: N5000.3S.25

Capacity(mAh) 5000
Config (s) 3
Discharge (c) 25
Weight (g) 403
Max Charge Rate (C) 5
Length-A(mm) 169
Height-B(mm) 48
Width-C(mm) 25
Update/Add my own data
Customer Data

Weight: 501g
Quantity: 
International Warehouse
stock
10+
Price  HKD333.45

Related Products
Customer Also Bought
Further discounts available for registered & logged-in customers.
 Customer rated
518
crowns
  
 
Total of 15 discussions.
Ian  1 points - 11/1/2014
 
I am trying to get info on charging systems for this battery. Newbie to it, can someone suggest what i need please
 Roger 3262 points
You can start with with the accucel6 charger and a 50-60W power supply. If you are planning to use battery packs this big or bigger, you should invest in higher capacity chargers (200W and above).
Jason  2 points - 10/19/2014
 
Can this be used with the dji E300 propulsion system? 15a ESC and 920kv motors?
Devin  3 points - 5/8/2014
 
will this fit in a rustler ? idk max dimensions of rustler I mean with back tray taken out
BARIS DENIZ  46 points - 4/23/2014
 
what should be amp set up to charge this battery? i always setting my hobbyking battery charger as 2 A. - 2A is much enough to charge or dangerous for my battery life.??? or what should be? thank in advance
 minivipers 2 points
herzaman ağ*ı*r ağ*ı*r ş*arj etmek iyidir...pil ö*mrü* iç*in
 Ken 30 points
A safe charge rate for all LiPos is 1C or the Capacity of the battery, which is that big number on the side. In this case it is 5.0, so the safe charge rate is 5 amps max. Anything less is OK also but charging time will take longer. Hope this helps :)
Cainan  12 points - 10/29/2013
 
Would this battery be good for a quad setup with 30A ESC's, 1000kv motors with 10x4.5 props? or should I be using the 35-70C LiPo?
 Guyon33 84 points
It would be just fine, 5000mah x 25c = 125amps continuous .... I use these on a quad with hotter motors than those.
 Nodecir 2 points
This Battery works fine. I have Quad with same configuration as yours but with a 2.2 Ah and 30C.
Customer Reviews
Overall Rating
8th scale racer
5 likes
ValueUNRATED
QualityUNRATED
Like it?
Running in a Mamba Monster 2650. Charged and balanced perfectly. My battery came with 10 ga wire not 8 ga which is great.


No comments. Reply..

Overall Rating
sonnyhad
7 likes
ValueUNRATED
QualityUNRATED
Like it?
Running 2 of these in my Trex 600E. awesome! Can be back in the air with same batteries in 20 mins! 5C charge rate, more than my charger can put out, that's for sure but charges plenty fast at 10 amps.


1 comment. Reply..

Overall Rating
kamilhassan
12 likes
ValueUNRATED
QualityUNRATED
Like it?
Also using them in my trex 600e fits well and balanced well. Mild 3d =5 mins flight sports with low headspeed 6mins.


No comments. Reply..

Overall Rating
Brandon Moon
93 likes
ValueUNRATED
QualityUNRATED
Like it?
Bought thes for a LX Mig-29 EDF, these batteries are fantastic. all cells were in perfect condition recieved at 3.82 v per cell, well ballanced. and packaged very niicely. tremendous power increase over the stock batteries at only a 3.1 oz per battery weight gain. they actually drew 2 to 5 less amps, but wats was increased by nearly 500 as measured by my eagle tree logger.
I highly recomend these and will be buying more


No comments. Reply..

Overall Rating
Customer
1 likes
ValueUNRATED
QualityUNRATED
Like it?
Running 2 of these in my Trex 600E. awesome! Can be back in the air with same batteries in 20 mins! 5C charge rate, more than my charger can put out, that's for sure but charges plenty fast at 10 amps.


No comments. Reply..

.....click here to see all reviews
Aff. Link