USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Using these in my minimag. Seem to work OK. Lost a star because the top case came off two of them when handling. Put them back together no worries and applied a bit of CA glue to stop it happening again. Otherwise OK.
looks very nice and of a good quality. hope it'll do the job perfect
No comments. Reply..
Overall Rating
koby gaon
125 likes
Value
UNRATED
Quality
UNRATED
Like it?
looks very nice and of a good quality. hope it'll do the job perfect
No comments. Reply..
Overall Rating
slaanesh
339 likes
Value
UNRATED
Quality
UNRATED
Like it?
These are really nice servos except for one flaw - if you apply any small amount of pressure just above the BMS writing on the sticker, the gears bind! After install 2 servos in wings I found that a little bit of pressure in this area causes them to not function. This tolerance is too small in my case so I can't use these servos. It's probably due to the case being too thin and easy to squeeze.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved