Rhino 1250mAh 3S1P 20C Lipoly Pack

Total of 12 discussions.

MohElg

40 points - 7/30/2012

I am wondering if just connect the motor , the ESC and the battery together ,(without rx & tx)what will happen ?

crisxstyle

5 points

Hi! Don't try to do this operation, there is the possibility that the engine starts at full throttle, its very dangerous. However, most of hobbyking's esc have a safety system inside which prevent the engine to start if the receiver is not connected

ergocentric

137 points

Nothing will happen, the ESC is has a computer with safeties programmed in, without a signal the motor will do nothing.

Karen

13 points - 7/10/2010

what type of connedctor is it will it fit
http://www.hobbycity.com/hobbycity/store/uh_view
item.asp?idproduct=3729

pookemon

23 points

None of the SC/BECS I've bought from Hobby City came with the same plug - and your chosen product doesn't seem to mention the connector. I bought two of these batteries and they both came with Female "XT60" connectors. I removed them and used Deans plugs.

Bharata

29 points - 6/17/2010

are the dimension correct?

Emilio

49 points

yes it'correct dimension bye

Emilio

49 points

yes dimension are perfect

Emilio

49 points

yes the dimension are correct.it's a grat lipo

__seth

29 points - 3/11/2010

is this 3s(3series)? or 3s1p(3series1parrelell)?

Sebastian

84 points

it's 3s1p(3series1parrelell)

Emilio

49 points

it's3 in series because 3.7v*3=11.1v there isn't parralel

Tucker

13 points

Series, because the 3.7v x 3 = 11.1 if they were in parallel it would still be 3.7v.

Sebastian

84 points

3s1p :)

Emilio

49 points

3series

Tucker

13 points

3s(3series)

Chriss 31

21 points - 2/4/2010

My battery Rhino 1250 31P 20C is defective one cell is out of order .It never run
What is possible ?

Mattt

6 points

The cell is dead, but you can take the dead cell out and rewire to be a 2s battery. It should be fine after that.

juan andres

21 points - 11/24/2009

What type of connector are these batteries?

Emilio

49 points

XT 60 CONNECTORS

Mattt

6 points

It ships with an XT60. Matt

Tucker

13 points

A strange foreign connector. Most likely you will have to solder on your own connector of choice.

aretwodetwo

21 points - 10/18/2009

Will this battery fit in an Team
Associated RC18T? And if it will is it
safe to solder a deans or bullet
connector onto it?

Casey

6 points

It should fit, may be a tad wide, but RC18t's are pretty "loose" when it comes to getting a battery to fit. Soldering a different connector should not be a problem.

Dee Dee

114 points - 10/16/2009

can somebody tell me if the discharge plug was still T-connector (deans style)?

if not..what?thanks

Tucker

13 points

Its a strange connector that i have never seen before. Its something like xst-80 or something. I just cut it off and soldered on a deans.

Joseph

93 points - 9/8/2009

This pack works perfectly with my motor which draws 25 to 30 amps but with flight time is just average.

Malfamartin

940 points - 5/1/2009

I use this LiPo in 4 of my TX, which are build for 8 AA cells. I had to modify the compartment by cutting space for the battery. I use JST instead of the Deans. The balance connector is located on the outside via the edge of the lid. I always charge the LiPo with the JST-XH connector. I also bought a JST-XH Wire Extension 3S (20cm) as a charge/balance cord. If you whant to be on the safe side you can charge by taking the battery out. I don't, but I put it on a safe place.

3w_flyer

52 points - 4/21/2009

why can this item cannot be put in backorder ?

John

52 points -

Is this the same balancing lead that is used on Zippy batteries?

Beaufighter

1808 points

Yes, it is JST-XH

Melanie

33 points

Yes, it is.

Bharata

29 points

are the dimension correct?

Dane

16 points

dimensions are correct, overall good battery

Tucker

13 points

Yes, it is a standard balancing lead.

Customer Reviews

Overall Rating		Mark D likes
Value	UNRATED
Quality	UNRATED

14 thumbs up!

great battery, great quality, great price, I use it a RC18b with a 6800kv mamba motor and 25 amp esc, with 14/55 gearing.delivers a great punch and top speed, only gets slightly warm. the only thing is its size is listed wrong its 85x35x17 no big deal tho.

3 comments. Reply..

Overall Rating		karolpenconek 504 likes
Value	UNRATED
Quality	UNRATED

6 thumbs up!

Nice battery, runs on 10C no hot in small boat. Thx hobbycity

No comments. Reply..

Overall Rating		Malfamartin 668 likes
Value	UNRATED
Quality	UNRATED

4 thumbs up!

No comments. Reply..

Overall Rating		Rogerio Ferreira likes
Value	UNRATED
Quality	UNRATED

4 thumbs up!

Very nice batt with good price, zippy quality, they perform very good in my Robbe Gemini Flyng boat, more than 10 minuts flying time. :)

No comments. Reply..

Overall Rating		Phil likes
Value	UNRATED
Quality	UNRATED

3 thumbs up!

I use this in my Guru-Z belt drive 300 series CP helicopter and it holds 10.6V when pulling 11A static. an awesome pack for 300 class CP microheli's!

No comments. Reply..

.....click here to see all reviews

Rhino 1250mAh 3S1P 20C Lipoly Pack

Capacity : 1250mAhConstant discharge: 20CBurst rate: 30C (15sec)Configuration : 3S 11.1vPack size: 90x35x18mmWeight : 116gDischarge plug: XT60 PRODUCT ID: R1250-20-3

Capacity : 1250mAh
Constant discharge: 20C
Burst rate: 30C (15sec)
Configuration : 3S 11.1v
Pack size: 90x35x18mm
Weight : 116g
Discharge plug: XT60

PRODUCT ID: R1250-20-3