Please confirm your location:


Arkansas warehouse now open.
Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the Arkansas warehouse even better value!
  Item found in the following categories;
> Multi-Rotors, Drones & Parts > FPV Racing Drones > Flight Controllers
> Multi-Rotors, Drones & Parts > Flight Controllers & Accessories > Flight Controllers

  RATED:

AfroFlight Naze32 Rev5 Acro FunFly Controller

AfroFlight Naze32 Rev5 Acro FunFly Controller
AfroFlight Naze32 Rev5 Acro FunFly Controller

The popular Naze32 is here! Initially designed for use with small to mid-sized multirotor craft, it has become the go-to controller for a host of Multirotor projects and propheads.

The infamous Hamasaki AKA “timecop” was not happy with the limitations and performance an 8-bit MCU could deliver on current FC platforms, so he set out to make a flight controller that could take just about any demands a developer could throw at it, and thus was born the Naze32. At the heart of the Naze32 is a 32bit ST micro work horse of a processer, with untapped memory and cpu power and a host of equally impressive sensors. The Naze is also matched up with some of the nicest GUI programs and features to get the most out of your configuration.

The Naze32 comes as the most complete Acro Version yet, with both strait and 90deg pins for your preference and a matched break out harness.

The HobbyKing version is fully authorized and royalties are paid to the developer on each Naze32 sold.

Features:
• Flexible motor outputs, support various airframe types:
Quad/Hexa/Tri/Bi/Y4/Y6/Octo/Camera Gimbal. (Default is Quad-X)
• Up to 8 ch RC input - supports standard receivers (PWM), PPM Sum receiver (FrSky, etc), or Spektrum satellite receivers.
• Built in FrSky telemetry inverter (shared w/main port)
• Battery voltage monitoring
• Modern 32-bit processor running at 3.3V/72MHz (STM32F103CB).
• Onboard MicroUSB for setup and configuration
• LEDs so bright, they could blind you
• MultiWii-based configuration software for easy setup
rev5 hardware

Specs:
36x36 mm (30.5mm Mounting)
5.3 grams (no headers, 7.3 grams with)
2000 degrees/second 3-axis MEMS gyro + accelerometer (MPU6050)
Input voltage: Max 16V on input rail and up to 35V 6s on the voltage sense line

Included: 
Naze32 rev5
2x5 pin header
12x2 pin header - straight header option (break it into 4 2x3 for motors/telemetry pins) OR
3x6 right angle header and 2x3 right angle header - right angle option
1x RC breakout cable

Download User's Manual for rev5

Configuration software - Chrome Baseflight Configurator (preferred)
https://chrome.google.com/webstore/detail/baseflight-configurator/mppkgnedeapfejgfimkdoninnofofigk

Can also use 2.3 or newer version of MultiWiiConf (Java-based) from http://code.google.com/p/multiwii/downloads/list.

Software is open-source! Code repository at
https://github.com/multiwii/baseflight 



PRODUCT ID: 9171000510-0

Shipped from:
International Warehouse

Price

$17.99

Old Price

$24.99

acc.
  • HobbyKing FPV250L Long Frame Quad Copter A Mini Sized FPV Multi-Rotor (kit)

    Combo Price: $8.76   IN STOCK
    Add to Cart

  • KK2.0/ Naze 32 Super Bright Status and Alarm LED

    Combo Price: $7.95   IN STOCK
    Add to Cart

  • Y Adapter For KK2.0 KK2.1 and Naze32 Super Bright LED and Buzzer

    Combo Price: $1.95   IN STOCK
    Add to Cart

  • Piezo Buzzer for KK2 KK2.1 & Naze32 Flight Control Boards (1pc)

    Combo Price: $2.95   IN STOCK
    Add to Cart

  • HobbyKing FPV250 Quad Copter A Mini Sized FPV Multi-Rotor (kit)

    Combo Price: $9.95   IN STOCK
    Add to Cart

  • Turnigy Integrated PCB Micro-Hex (KIT)

    Combo Price: $0.95   IN STOCK
    Add to Cart

  • Hercules 500mm QuadCopter (KIT)

    Combo Price: $19.95   IN STOCK
    Add to Cart

  • HobbyKing Super-H 600 QuadCopter (KIT)

    Combo Price: $34.94   IN STOCK
    Add to Cart

  • Hobbyking SK450 Glass Fiber Quadcopter Frame 450mm

    Combo Price: $16.95   IN STOCK
    Add to Cart

  • FPV250LH Low Hung Clean-and-Dirty (KIT)

    Combo Price: $19.95   IN STOCK
    Add to Cart

  • Laser230 FPV Quadcopter Composite Kit (230mm)

    Combo Price: $22.95   IN STOCK
    Add to Cart

  • Mini Flight Controller Mounting Base 30.5mm Naze32, KK Mini, CC3D, Mini APM (30.5mm,36mm)

    Combo Price: $1.83   IN STOCK
    Add to Cart



Further discounts available for registered & logged-in customers.
This item is on a flash sale right now.
The standard price is: $24.99.
Sale ends in:9095hrs
 Customer rated
563
crowns
  
 
Total of 244 discussions.
goran  5 points - 4/5/2016
 
how to make a stick arm with spectrum **5e . I've tried everything but can not arm . where the error ? Throtle ok , but how that arm ? thank you for your reply.
 goran 5 points
I have rev5 akro
 Matthew 14 points
Under the receiver section, make sure your yaw throw reaches about 2000 and your throttle reaches close to 1000. They need to be quite close to those values to arm. You may need to increase your end points if they do not. This is usually caused by adjusting your rate settings on the radio. Reset your rates and try again. you can set your rates under the receiver section of the configuration software.
BEST ANSWER CREDIT AWARDED
 goran 5 points
Thanks Matthew to answer I do not know how to change the value Yav . Throtle is 900min Yav I can not adjust . maybe. the cli writed ?
 Matthew 14 points
If you haven't already, consider cleanflight firmware. Also arming by switch is an option under modes. What Radio are you using?
 goran 5 points
I have Spectrum **5 . Svich arm in good working end fly . Stick does nothing works
 goran 5 points
spektrum **5e
 Matthew 14 points
Under the setup tab on the configurator, try resetting to defaults. Then try inputting your settings again. I have found if settings aren't cleared out after a firmware update things can behave strangely.
Erkan  1 points - 1/19/2016
 
I have an issue with the Naze32. When I'm flying around and do some banking on the Ground, the Gyro calibration in Horizon Mode will be lost. Then my quad just drifts heavy to one Direction until I reconnect the Battery, sometimes disarm and arming is helpful.
Did anybody have had this problem and is there anny solution?

THX
Quadcopter102  12 points - 1/4/2016
 
Why is it that - I am in Aussie - I choose the AU store- I add a Naze32 to cart - I go to checkout...shipping is NOT within Aussie. This item would fit in a well padded postal bag/envelope not bigger than 6inches X 4 inches. And land delivery courier of OzPost about 150 klm to my home - would be around au$10 and take 3 days at most. HK really does soak up some cash with overly high shipping charges. And ship from outside Aussie when its supposed to bu in Au store.... getting more disheartened using this outlet.
 Conor 23 points
It is not in the AU warehouse, are you an idiot? It clearly says International warehouse.
engnr  147 points - 12/29/2015
 
I recently put one of these on a new QAV500v2 quadcopter. I wasn't sure if it would work very well out of the box, having only used 250 sized quads with the Naze32, and a local 'expert' telling me it wouldn't work, but I have to say it flies beautifully, very stable and easy to fly (using Cleanflight). Great!
silvana  18 points - 12/27/2015
 
Are this able to handle a GPS?
 Chad 7 points
No you will have to but the full name with magnetometer and barometer
 Chad 7 points
Sorry, typo I ment to say you will need the full naze controller if you want gps
 engnr 147 points
I have a rev6 acro naze32 here and it has GPS pinout available to connect a 3rd party receiver to.
Customer Reviews
Overall Rating
Jared
5 likes
Value
Quality
Like it?
By far the best flight characteristics of any FC I have purchased so far. The soldering was was easier than expected although hotknifing the bent leads was necessary for my fpv250 Build(used them for vertical attachment of reciever breakout). Setup was easy even though i had never used the chrome baseflight configurator.just follow setup guide in HK file folder. With autolevel on was still able to do flips.


1 comment. Reply..

Overall Rating
Mastermad
15 likes
Value
Quality
Like it?
Goodbye kk2.1, hello Naze32! spent 1h on the net and learnt all i needed to know, got it set up on my tricopter, took it out and... O_O' "me love". me by more of this!


1 comment. Reply..

Overall Rating
vincent
7 likes
Value
Quality
Like it?
Poor solders on the board, has lost a capacitor :/ and need to correct some other solders Mounted on a laser230 frame... not easy to adjust settings. Hope that my BT module help me to find correct PID's! Has sometimes YAW issues when trying flips (the quad slide a lot on the yaw after a recovery)... many people speak of this good FC but I'm not very satisfied by the overall quality


2 comments. Reply..

Overall Rating
DELAIN
10 likes
Value
Quality
Like it?
Mounted one on Black Out Mini H quad clone (Motors : 1804 2400KV, Props : Gemfan 5*3, Battery : Lipo 3S 1300 mAh Nanotech). Fligth Controller very easy to setup (with Baseflight Chrome extension). If flies marvellously well even in gusty wind condition. The quad seems to be on rails. Now, I have to sell my KK 2.x, Multiwii xx,... and replace them by this FC. Thank you HK.


2 comments. Reply..

Create an account
Overall Rating
Paolo Pinsone
81 likes
Value
Quality
Like it?
Amzing little board , remember this one has no mag and no baro so basicly its like a KK2 but much more locked in i was amazed it worked out of the box on a mini that i had to tweak for hours with the kk2! KK still nice for beginners but this board also works for beginners... just remember to turn on the "feature motor_stop" in the CLI


2 comments. Reply..

.....click here to see all reviews
Aff. Link