USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
If you count how many magnets there is in the can, thats the number your after. I just guessing here, it probably is a 12 toothe stator and with 14 magnets (poles). High timing is normaly used with outrunners with many poles.
i want to buy a motor with operating voltage of 18-20volts
and i want to use it at 20 ampere current.
i require power of more than 300 watts(practically) what motor should i buy...!
Hi mardio! It does not matter which wires are which and I will tell you why. Any 3 wires can be hooked up to your speed controller in any order. If your motor runs backwards simply switch any two wires! Easy
you have to conect the 3 wires to the esc, then turn on. If the rotation is Ok thats all if not disconect and conect in diferent order. This is an excelnt motor. I have it in a 2.1 Kg trainer whit a 60 amp esc.
Gerald that depends on the power system combo you choose to use. 3s 2200 ok got that but now you must decide which prop size to use. Remember that the amp rating is 30amps on a 3s.
Could anyone tell me the break down in the Dimmensions of this motor? My stock motor on my E-flite Apprentice is plastic and cheap. Dimmensions are approximately- Motor housing=50mm (1.96in) Protruding shaft=12mm (.472in) Overall=62mm (2.51in).
anything shorter may not work... Anyone have any ideas or recommendations? tav
KDA36-10XL Constant: 900Kv Battery: 3/4/5 Cell Lipo Operating Current: (3Cell=30A)(4Cell=21A)(5Cell=17A) Peak Current: (3Cell=42A)(4Cell=32A)(5Cell=25A) Suggested Prop: 13x6.5 KA36-XL Shaft Size: 5.0mm x 20mm Motor Dimensions: 37.4mm x 48 I too am shopping for a new motor as mine took a hit from a light pole lol this motor seams to be the right size
Customer Reviews
Overall Rating
Paul Burns
likes
Value
UNRATED
Quality
UNRATED
17 thumbs up!
Bare weight of the motor without accsesories is 184g. Prop tests on a 3cell 11.1v 2100mAh D9 Lipo: Aeronaut 12x8 folder 8000 rpm 42A APC E 12x6 8200 rpm 40A 4lb thrust APC E 11x8.5 8100 rpm 42A 3lb thrust APC E 11x8 8200 rpm 38A 3lb thrust APC E 11x7 8500 rpm 34A 3.4lb thrust
Motor measured at 975Kv.
No comments. Reply..
Overall Rating
alistair farmiloe
likes
Value
UNRATED
Quality
UNRATED
3 thumbs up!
bargain outrunner, nice power and the spec is the same as the hacker a30-10xl so good for using on the motor calculators. slightly noisier than the hacker and torque motors, and the finish is no where near as good, but 4 stars for this as its a good price.
Excellent motor for planes like the Sebart Sukhoi 29 30e with 3s lipos and 13x3,6 or 14x7 APC prop. it has enough power to pull the plane out of a torque roll. 5 minutes flight time with 2200mah 3s zippy and just 1600 mah consumed.
1 comment. Reply..
Overall Rating
Ronald Evans
likes
Value
UNRATED
Quality
UNRATED
1 thumbs up!
I really like the color scheme and that's where it ends. Put the motor in an Acromaster with a 11X7 prop. Did a test run-up and noted a heavy vibration above half throttle. I rebalanced everything to no avail. Took the motor out and noticed one of the magnets had slipped forward and appeared loose. Took the can off and found 3 loose magnets. Put it back together and it still vibrated. Took it apart again and found that the 5mm shaft was bent. This motor has never been flown.
Also noted that the bearings were loose fitting and the windings were loosly wrapped. No more KD's for me.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg){kind=small}
