Please confirm your location:


  Item found in the following categories;
> Batteries & Accessories > Li-Poly (All brands)
> Batteries & Accessories > Rx/Tx Batteries
> Radios & Receivers > Turnigy
> Batteries & Accessories > Turnigy Lipoly

  RATED:

Turnigy 9XR Safety Protected 11.1v (3s) 2200mAh 1.5C Transmitter Pack

Turnigy 9XR Safety Protected 11.1v (3s) 2200mAh 1.5C Transmitter Pack

This battery is designed exclusively for the New Turnigy 9XR radio system.

The pack has both over charge / discharge protection and over current protection built right into the battery, this adds significant safety to the 9xr system.

 

Spec:
Capacity:  2200mAh
Voltage: 11.1v
Constant discharge: 1.5C (3.3amps)
Max charge rate: 1C (2.2amps)
Standard rate: 0.5c (1.1amps)
Charge cut off: 12.6v
Discharge cut off: 9.0v
Over current cut: 5 amps
Burst discharge: N/A
Weight: 139g
Size: 100x33x19mm
Plugs: JST & JST-XH

 Note: This battery is only to be used in Radio Transmitters



PRODUCT ID: 9171000183

Capacity(mAh) 2200
Config (s) 3
Discharge (c) 1.5
Weight (g) 139
Max Charge Rate (C) 1
Length-A(mm) 100
Height-B(mm) 33
Width-C(mm) 19
Update/Add my own data
Customer Data

Weight: 192g
Quantity: 
International Warehouse
stock
10+
Price  HKD100.80

Related Products
Customer Also Bought
Further discounts available for registered & logged-in customers.
 Customer rated
563
crowns
  
 
Total of 337 discussions.
willr  5 points - 12/11/2014
 
Why can it only be used with 9XR Tx? I have in mind use for a r/c toy (wifi battle tank from HK) that takes 8 X AA battery or Ni-Cd / LiPo alternative with JST connector like this battery. Voltage looks OK. Can't believe toy tank takes more than 3A current. Should be OK?
 AlexRaz 155 points
That should be fine.
 EffinA 1933 points
The max draw on this battery is 1.5c. Make sure the tank does not pull more than about 1.8A or so, or it will not work. There are plenty of batteries with a higher discharge rate, but I understand that you want the over discharge feature.
kuya1  6 points - 12/6/2014
 
Loose fit , I installed it in my new 9XR everything is fine except it loose and rattles inside the transmitter any idea on a fix foam possible , didn't anybody else notice it ?
 Dan 6 points
Yea, it shakes around if you move your transmitter. I recommend you put some foam inside there if you see it as a major problem or annoyance.
 AlexRaz 155 points
That's why the 9xr comes with the black adhesive foam. You just need to cut it to size then stick it to the inside of the battery compartment. That would make it a perfect fit.
ROBINSON  1 points - 12/4/2014
 
Hello ! Why is so expesive to send this battery to Brazil ??? Regards. Robinson
 AlexRaz 155 points
Because it has to go through an expensive courier like FedEx. Other couriers do not accept lipo batteries.
phil alvirez  53 points - 12/2/2014
 
more data: hkny is telling me that for chargers with 2 ports you connect the red plug to charge port and the white to balance port, so now we have data for this kind of chargers. now we need to hear from them about chargers with 1 port that charge and balance through it, like mine. in this the white should go to the charging port-that is my guess, but wait until they confirm this.
phil alvirez  53 points - 11/29/2014
 
mine came with the yellow and blue wires sliced so there is no contact. only the red and black are ok. i have contacted a fellow who owns 1, and he says his came with all wires connected, and he uses this white connector to plug into his charger so it will charge and balance all 3 cells as lipos have to be charged and balanced individually. the red plug, that seems to be for charging, would charge the ends cells and the 1 in between will get less charge, so it will be unbalanced. i hope that eventually they will correct this and also provide instructions on what plug to be used for charging.
 AlexRaz 155 points
I use the Turnigy Accucel 6 to charge this and my other lipos. You connect both the white plug (balancing) and the red plug (with 2wires) to the charger. Note that the charger does not come with a power supply. I use an old PC power supply to power the charger.
 Lotfi 8 points
I noticed on mine that when closing the battery door of the 9XR, it can possibly damage the 4 cables of the balancing connector that powers the 9XR. So close it carefully. Also, I do not recommand charging the battery with the built in plug on the 9XR. One should charge it using a balancing charger (example Imax B6) after REMOVING it from the 9XR for safety. Hope it helps.
Customer Reviews
Create an account
Overall Rating
kassioregalin
7 likes
Value
Quality
Like it?
Excelente bateria ótima duração da carga...


3 comments. Reply..

Create an account
Overall Rating

14 likes
Value
Quality
Like it?
Change NiMH On LiPo 2200mAh and has forgotten about problem of the charging on field...


No comments. Reply..

Overall Rating
EffinA
1930 likes
Value
Quality
Like it?
I have tried out the 9xr battery, and I am pleased with how it works. I put it in my 9xr, and ran it on the simulator. It is holding up very well (all I am running is the TX on it), and I expect no problems. I am setting up my 12V dremel tool to run on it too (and any 3s LiPo), but I see this one as a good option for it's over and under protection. If my dremel runs it out, it will cut off, so this should work nicely.


6 comments. Reply..

Create an account
Overall Rating
Mimax
3 likes
Value
Quality
Like it?
Se esta a pensar em compara um 9xR, compre também esta bateria, é imprescindível. No meu caso a fazer uns 30m de voo por dia, dura já à mais de duas semanas sem recarregar :-)


2 comments. Reply..

Create an account
Overall Rating
modifiedmustang
556 likes
Value
Quality
Like it?
The battery fits nicely, albeit there's quite a bit more room for a taller (when looking at the photo) pack, but this one give more than enough for several days of flying without a charge.


1 comment. Reply..

.....click here to see all reviews
Aff. Link