hi, noob question here, apparently hk doesn't call them wires, cables, or leads, receiver wires, controller wires or servo wires. I have been trying the search here with no joy, All I find are F to M servo "extensions." Please, where do you buy those 10cm - 20cm "male to male" bright, plastic coated magic-metal strings with plugs, designed to connect the pins on these boards to the RX? Seriously.. Thanks! **divot (I'm looking for the exact same wires pictured with HKPilot Mega Here: http://www.hobbyking.com/hobbyking/store/__37328__HK
Hi John, you can find them here if you do a m-m search. ebay has them also in a package of ten. their called male to male servo leads. get the 24awg, and not the 26awg. you can find them in 4" up to 12"
I have a set of 4" ones and 8" ones (5ea) that I am not using, if you need them, send me an email.
the project i am trying to setup is a plane and it consists of 7 servos.the movement of the first two is my main problem and i am describing or trying to do so in my previous question...can anyone help?
of course it depends on your transmitter, if it can sign mixers to any controllers,
(in your case- potentiometers) and setup endpoints- so You can get your needed 1-180 degrees with one potentiomter, and 0-20 with other :)
hi!i want to try programming the movement of 2 servos,controling them with a potentiometer and moving together them in real time anywhere from 1-180 degrees and with a second potentiometer control the same two servos and move them in opposite direction from 0(same position) to 20 degrees in opposite direction.when i move the first potentiometer i want them to keep the previous difference in angle.plz can anyone help me!
Hi i am new to this can any body tell if this is ok to connect gps/bar/mag/to a fc through I2c and if so where can i get wiring diagrams as where to wire to and what leads do i need. thank you
Dommage qu'il n'y ait aucun schéma. Quel est le brochage de LCD parallèle, LCD série, , SD, URF01, ... ?
No comments. Reply..
Got mine in yesterday. I love it! Good solder work. All works fine. The two screw terminals power the adruino and supply unregulated voltage to the servo/sensor ports. Be careful not to plug your arduino into your computer with the external power supply connected and the power jumper in place. Tripped my computers psu.
Produto muito bom mesmo otimo acabamento este eu comprei apenas para utilizar junto com o display 64x128 por ja ter as conecssoes corretas mas acabei utilizando para varias outras coisas pois ele te da suporte para quase tudo e o melhor com preco muito baixo