USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Its no “Mystery” where these ESCs are made, now they are available to you at HobbyKing prices.
Built with imported N-Channel mosFET's and an ultra fast Atmel MCU & heartbeat make this a high performance ESC with excellent sync capabilities. Programmable via an R/C controller.It allows you to program all functions to fit your specific needs, which makes it efficient and user friendly.
Features: Extremely low internal resistance Super smooth and accurate throttle linearity Over heat and over-load protection Auto shut down when signal is lost or radio interference becomes severe for more than 2 seconds Supports high RPM motors Power arming protection (prevents the motor from accidentally running when switched ON) New Advanced programming software
Programming features: Brake setting (we recommend using brake for only folding props applications) Battery type(LiPo or NiCd/NiMh) Low voltage cutoff setting Factory default setup restore Timing settings (to enhance ESC efficiency and smoothness) Soft acceleration start ups (for delicate gearbox and helicopter applications) Governor mode(for helicopter applications) Motor rotation( clockwise\counterclockwise) Switching frequency Low voltage cutoff type (power reduction orirnmediate shutdown)
Factory default settings: Brake: off Battery type Detect: LiPo with Automatic Cell Low voltage cutoff threshold: Medium (3.0V/65%) Timing setup: Automatic Soft Acceleration Start Up: Medium Governor mode : OFF Frequency : 8kHz Low voltage cutoff type: Reduce power
I must add they are great esc's no flaws and have a great throttle response for my quad. Programmed all at once with a 6 to 1 splitter i made with an old 6 channel receiver
I have a 3-Cell LiPo that I use on an indoor foamy with this plane. After just being plugged in, the ECS becomes very hot, without pulsing the throttle, and have smoked a few. That was at 11.1V, let alone a 4-Cell. You'd be better off with a better ESC if you are going 4-Cell.
I just discharged my one of my 4s lipos on 6 of these esc's in a hex, so they will plug up. I tested with no prop though.....awaiting carbon fiber props.
Nice linear throttle response. Great for hovers and whatnot. You can make them even lighter depending on your application by removing most of the wire. I actually removed all the wire on the motor side and soldered a 2205c motor directly on and left just enough on the batt side to solder a JST conn, plus about half the RX wire. I know, I'm anal but... saved about 3-4 grams and it seems to work great. Hey, it all adds up.
Perfect fit for the depron foamies in the U.S. warehouse. Easily programmable, very lightweight and very high quality.
No comments. Reply..
Overall Rating
boisebiker
15 likes
Value
Quality
Like it?
Simple to use. Works great on 7oz foamy with 28g motor. I bought 2 and 1 of them quit after 6 flilghts so I had to knock off a couple of stars. Second one is going strong and I will buy more when I need another.
No comments. Reply..
Overall Rating
1/28/2013 David
22 likes
Value
Quality
Like it?
I put two of these in a micro A-10 with EDF's. I soldered the leads to the motors and with the programming was able to reverse one motor after it was soldered. Size, weight, and programmability make this ESC a good one.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg){kind=small}
