Turnigy TrackStar 13.5T Sensored Brushless Motor 2590KV
The Turnigy TrackStar Sensored Brushless Motors offer outstanding performance at an incredible price!
Featuring a quality anodized CNC motor can, hand-wound high purity copper windings and powerful sintered neodymium magnets, you wont find a better priced motor of this caliber anywhere else! They also feature adjustable timing which allows for fine tuning the performance of your ride while the sensor ensures smooth startups and acceleration.
The TrackStar brushless motors make a great upgrade for 1/10th short course trucks, buggies, touring cars or anything else that uses 540 size motors.
Features: • Sensor-Based for Excellent Torque and Low-Speed Driveability • Adjustable Timing • Compatible with any Sensored/Sensorless ESC • CNC Machined Billet T6 Aluminum Motor Can • High Purity Copper Windings • High Power Solder Tabs • Removable/Replaceable Rotor • Powerful Sintered Neodymium Magnet • Precision Engineered for Maximum Energy Conversion
*Note: Sensor cable included
Specs: Can Size: 540 Turns: 13.5 RPM/v: 2590kv Poles: 2 Sensored: Yes (Standard 6 pin harness) Max voltage: 11.1~14.8V (3~4S) Max Current: 21A Max Watts: 310w Resistance: 0.0363ohm No Load Current: 3A Shaft Size: 3.175mm Can Diameter: 36mm Can Length: 51.5mm Weight: 156g
I haven't personally used it with that ESC but I know it will work. The sensor wire is so that the motor avoids cogging when going slow by sensing where the rotor is and applying power accordingly.
Hope this helps :)
is it possible to remove the sensored half . if not is there a sensor plug cover i dont want to short the motor and esc . i treat my rc car like a boat . i sumberge it in sloppy clay water and othe stuff
I would not suggest you use the motor in this way mainly due to the motor vents you would get grit inside the motor can but if you must I would put insulation tape around the motor vents and seal the sensor connector with silicon
I would not do this first it would invalidate the warranty secondly adding metal mesh would affect the magnetic field of the motor, if i was doing a pro looking job i would first seal the motor then encase the whole motor in a large flexible nylon cable braid
the timing should adjust how much power or speed you want draw a straight line and put power at one end and speed at the other . now right in the midlle its balanced . so if you want to go faster you loose power . or if you want more power you loose speed . its weasy to understand
An awesome motor! Extremely silent and smooth; even when used with a sensorless ESC, it gives an excellent performance...
3 comments. Reply..
Ive just put the track star 13.5T motor in a mardave V12. I highly recommed this motor for racing its very smooth with the and has great pick up on the staights Im using a core 45 speed control with a program card the lipo im using are nano 5000 3.7V and zippy 6000 3.7V. I going to order a second one as there that good. Happy Racing!
No comments. Reply..
really nice motor , very good torque and smooth,runs nice and cool , actual build quality is superb, no gaps around the wiring point or harness connector to allow dirt in, timing adjustment at the end bell is nice and easy with just two screws and easy to grip recesses with good clear timing markings , leave it set to 30 degrees if you are running with reverse enabled .
for the price this is a great motor , not the fastest 13.5 i have had but for street running or racing on a very tight track with a bit of timing advance on the esc its brilliant.