USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
hey i have the solve to the front sway bar back plate not fitting all you need is a good hobby knife the back plate and about 5 min of time use the plate to get you outline and then just carve away till it fits flush then mount it to the fr diff with two screws one on top and the other on the opposing side on the bottom then put the ***per on and put the other 2 screws in and you done i have posted 2 pics in my al*** of what mine looks like done. give it a try its better then not using it at all ya know
yet another part that is great but not quite right the part works great for the back and i am shure that it would work great in the front if you dont want to use the ***per i have looked at every posable way and there is no getting it to fit aside from cutting and glueing and fabin you own part that will most likely break if it hits anything
locks the stabilizer bar to the front differential. and rear differential. in the package there are two pieces. this up grade is mounted in the extreme rally car 1/16 and all the other cars that have the same differential and arms
locks the stabilizer bar to the front differential. and rear differential. in the package there are two pieces. this up grade is mounted in the extreme rally car 1/16 and all the other cars that have the same differential and arms
Stabilizer straps, front n rear. The original ones are 2 piece w. adjustable grub screws. Save these and mount the aluminum parts, run in grubs to desired tension. I bought these just because, but there's no practical use for them. The stock plastic ones would probably never break.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg)
