This servo is big enough to handle large antenna tracking systems for FPV! This 360 degree servo can perform up to 6 complete revolutions and with it's fast response and good reslution provide smooth antenna tracking opperation. You can also use it for a sailboat winch too!
Features: Coreless motor Dual ball bearings Futaba style splines Heat sink aluminum middle casing Water resistant
Spec; Weight: 64 grams / 2.26 oz. Dimensions: 40 x 25 x 49 mm / 1.57 x 0.98 x 1.93 inch Torque At 6.0V: 9.8kg-cm , 136.04 oz-in Torque At 7.2V: 12kg-cm , 166.65 oz-in Speed At 6.0V: 0.9 sec / 360° at no load Speed At 7.2V: 0.75 sec / 360° at no load
Where can i find different servo horns that will fit this? the winch horn isn't appropriate for my FPV pan/tilt antenna tracker needs- and anther customer said the splines aren't futaba and therefore very hard to find different servo horns that will fit..? thanks in advance
Have not yet fitted it to a boat but it has tested ok. Appears well made for the price but is a bit slow and only does a total of two revolutions. The drum is only 31mm or 1.25inches in diameter so it shouldn't have a problem pulling on a fair sized sail. Hope this helps
2 comments. Reply..
I got similar analog winch from r2 hobbies before, this is the same model and work great even for a 1 meter sailboat on 5AA pack.
servo arrived with wrong accessories (wheel) with different size/diameter of splines. Wheel is for different servo.
Otherwise I'm happy with thist servo, I will use it for FPV ground station, but I have to find a horn/wheel that will work with this servo.
5 comments. Reply..
Servo is fine but the biggest problem I have is the splines are NOT futaba. They are much larger than futaba, so if you purchase to change the servo horn the servo is pretty much useless.