USA warehouse now open.
Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
  Item found in the following categories;
> Batteries & Accessories > Li-Poly (All brands)
> Batteries & Accessories > Airsoft
> Airsoft & Accessories > Lipoly Batteries

  RATED:

Turnigy nano-tech 1200mah 3S 15~25C Lipo AIRSOFT Pack

Turnigy nano-tech 1200mah 3S 15~25C Lipo AIRSOFT Pack

When it comes to putting rounds down range, no one wants to compromise on fire power! thats why the legendary Turnigy nano-tech batteries are now available for Airsoft combat. Higher motor RPM, less voltage sag and extended operating times equal better performance from your weapon of choice.

The nano-tech Airsoft series also feature 5C charge ratings putting you back on the front line faster!

Get an unfair advantage and make sure your opponents know that they have been taken out by nano-tech!

Spec.
Capacity: 1200mAh
Voltage: 3S1P / 3S Cell / 11.1V
Discharge: 15C Constant / 25C Burst
Weight: 94g (including wire, plug & case)
Dimensions: 128x17x20mm (Each)
Balance Plug: JST-XH
Discharge Plug: Mini-Tamiya (Mini Molex)
 
The nano-core technology in lithium ion batteries is the application of nanometer conductive additives.
 
1) The nanometer conductive additives form ultrastrong electron-conducting networks in the electrodes which can increase electronic conductivity.
2) These additives create a superstrong ability for imbibition in the carrier liquid to supply more ion channels. This improves the ability of ion transmission and ion diffusion.
Through improving electronic conductivity and ion transmission, the impedance is reduced and the polarization of high rate discharge decreases greatly.
 
Advantages over traditional Lipo batteries:
-Power density reaches 7.5 kw/kg.
-Less Voltage sag during high rate discharge, giving more power under load.
-Internal impedance can reach as low as 1.2mΩ compared to that of 3mΩ of a standard Lipoly.
-Greater thermal control, pack usually doesnt exceed 60degC
-Thickness swelling during heavy load doesnt exceed 5%, compared to 15% of a normal Lipoly   during heavy load.
-Higher capacity during heavy discharge. More than 90% at 100% C rate.
-Fast charge capable, up to 15C on some batteries.
-Longer Cycle Life, almost double that of standard lipoly technology

*Note: The length of Balance charging wire may vary


PRODUCT ID: NG1200A.3S.15

This product available from a warehouse near you!

Capacity(mAh) 1200
Config(s) 3
Discharge(c) 15
Weight(g) 94
Max Charge Rate (C) 5
Length-A(mm) 128
Height-B(mm) 17
Width-C(mm) 20
Update/Add my own data
Customer Data

Weight: 145g Quantity: 
United States Warehouse In Stock View Item
stock
10+
Price$8.97


acc.
  • Male Mini Tamiya/AR Drone/Airsoft to Female XT60 (3pcs/bag)

    Combo Price: $1.49   BACKORDER

  • Mini Tamiya Female Connector (10pcs/set)

    Combo Price: $1.31   IN STOCK

  • Mini Tamiya Connector Male (10pcs/bag)

    Combo Price: $1.34   IN STOCK



Further discounts available for registered & logged-in customers.
 Customer rated
510
crowns
  
 
Total of 3 discussions.
Khrisna  203 points - 3/22/2014
 
first time it arrive, then i check it by voltchecker soon, then i go upset when it show only 2s active in total 7.89v. is here anyone can help me about that case?
 Xavier 3 points
The batteries are shipped with a load of "Maintenance" on a 30% to 40% of rated load, is the best way to not degrade the Lipo batteries. Put it on the charger and then check the voltage, which really increases. regards
tony  144 points - 4/13/2013
 
I wonder if I can use this battery pack for my Flysky TH9X transmitter with Dragon Link pack?
I guess 1400 ma should handle 500mw for that Tx combo?
Can someone confirm my idea?
 jay2_deguzman 122 points
we normally use this in airsoft mate. its burst is usually high due to rapid or full auto firing, i guess you could use this as long as the voltage required is the same. goodluck!
Evgeniy Anatolevich  13 points - 7/5/2011
 
This is what you need. Only the required length (more capacity) and voltage of 7.4
 e_lm_70 702 points
If it has so low internal resistance ... why only 15C max discharge ? Anyhow, I got it since I need for the 50mm mini EDF ... and these just need around 18Amp ... so just inside the capacity ... and for same weight they deliver 20pcnt more capacity compared to 1000mAh 3S 25C packs
 joseph 14 points
The nano-core technology in lithium ion batteries is the application of nanometer conductive additives. 1) The nanometer conductive additives form ultrastrong electron-conducting networks in the electrodes which can increase electronic conductivity. 2) These additives create a superstrong ability for imbibition in the carrier liquid to supply more ion channels. This improves the ability of ion transmission and ion diffusion. Through improving electronic conductivity and ion transmission, the impedance is reduced and the polarization of high rate discharge decreases greatly. Advantages over traditional Lipo batteries: -Power density reaches 7.5 kw/kg. -Less Voltage sag during high rate discharge, giving more power under load. -Internal impedance can reach as low as 1.2mΩ* compared to that of 3mΩ* of a standard Lipoly. -Greater thermal control, pack usually doesnt exceed 60degC -Thickness swelling during heavy load doesnt exceed 5%, compared to 15% of a normal Lipoly during heavy load. -Higher capacity during heavy discharge. More than 90% at 100% C rate. -Fast charge capable, up to 15C on some batteries. -Longer Cycle Life, almost double that of standard lipoly technology
Customer Reviews
Create an account
Overall Rating
ppxav
1008 likes
Value
Quality
Like it?
nice fit in stock crane style eag .
put one in each "tube"
this will allow a spare battery , just removing buttplate on the field.

and more this is a nanotech technology , allowing fast charge.

a must to have for airsoft players.

don't forget to check voltage compatibility, not to burnup everything.
cheers


No comments. Reply..

Overall Rating
Collat3ral
13 likes
Value
Quality
Like it?
Fits in the back of a Magpull UBR and all of the stock tubes. The best part is, they are cheap. With a 5C charge, you fill them up in 10 mins :) Fits everywhere, where the stock 8,4V goes. And it's so damn cheap. Used it for about 20k rounds, still going strong, no sign of inflating or loosing capacity. A must buy if you're using li-po batteries.


No comments. Reply..

Overall Rating
__Jawz
21 likes
Value
Quality
Like it?
* Summary Very nice LiPo for airsoft guns at a great price! There is absolutely no reason to buy the more expensive Firefox or Flame brands. The main wires are pretty long (slightly over 140mm incl. connector), while the balance tap measures around 80mm. I usually get rid of the Tamiyas and convert them to high-current T-connectors instead. * Application One of these stick LiPos fits nicely in a buffer tube if you are using a Magpul MOE stock. But you can *double* the capacity (ie. to 2400mAh) if you use two of these LiPos in an H&K 416-style crane stock in a parallel configurationwith a parallel adapter, of course, that you can solder on your own. More info here: www.link can do the same parallel configuration with many other front-wired M4s that still use the *plastic heat shield.* Definitely works in a APS M4, ICS M4, and JG M4 CQB. This LiPo stick also fits in a G36 handguard.


No comments. Reply..

Overall Rating
Marko
3 likes
Value
Quality
Like it?
Very nice product for Airsoft use. You can use it in crain on the back of replica. If it would be 1mm wider or higher it wouldn’t fit into the tube. I do not advice it for any gear. It gives a lot of torque and high rotation speed. You can load the spring up to 160m/s. I would appreciate if would be possible to made 20mm shorter battery. The power and balance cable should be made of maximal length 25-30mm.


No comments. Reply..

Overall Rating
Colonel249
2 likes
Value
Quality
Like it?
GREAT BATTERIESS!!!!! They came very well balanced (2nd cell was only 0.02v off) These fit almost all cranestocks, G36 handguards (KWA), buffer tubes and of course, full stocks. They dont fit in M4 handguards (KWA tested) or AK top covers. (Dboys) I have not tried it in Mp5s that have the battery on top, but i imagine they wouldnt fit. Great batteries! 5/5


1 comment. Reply..

.....click here to see all reviews
Aff. Link