Gday, I was wondering in the required section it does not state anything needing a control board or an arduino to run the system, what controls the system then? is anything else needed that is not in the required section?
Ben this is basically a DIY unit..You need to decide on the RX/TX (2ch) for Rudder n Speed control...then you would have to decide on power house (Motor/ESC/Batt) This are just for starters, you would need a motor mounting, the propeller shaft along with the propeller size...not forgetting the Rudder kit..... I*m more of a scratch builder (Foam/wood) and hope the info provided is helpful.......consider using a waterjet propulsion less headache (RX/TX/ Jet/ESC/Batt)
Very nice hull, with a good design. Good quality for the fiberglass material. Well finished gel coat.
No comments. Reply..
Quality : The fiberglass was consistent with no noticable flaws, very rigid and durable. I liked the fact the "graphics" were painted on. Value : I paid under $38 for this hull. Value? ABSOLUTELY ! Overall Rating : The hull was packaged in plastic, custom cut foam supports for the hull and both the bow and stern, then bubble wrapped and boxed in a "FRAGILE" marked box. So it arrived in good shape. I will review further after getting it set up and in the water. I am planning around a Feigao 2040 Inrunner 3800 kv, 1/8 flex drive with Micro Strut & Rudder turning a 430 metal prop with 2S LiPos controlled by a Turnigy 35A Boat ESC with BEC.
3 comments. Reply..
I just picked one up, it is small, and solid.
Anyone has the manual? Do I just "tape" the top cover? Kind of weird if I need to do it every time to charge/change battery?
6 comments. Reply..
Der GFK-Rumpf ist gut gearbeitet, glatte Oberfläche aussen,
Er ist stabil, auch nach Loppings keine Propleme.
Platz zum Einbau der Teile ist genug.
Für mich tolle Preis-Leistung, meine Empfehlung.
Im Video sieht man die Fahreigenschaften auch gut.