Adjustable Stinger Drive

 mark 13 points

using mine with a 3/16 flex cable

 kaime 12 points

is for a 4,76mm flex cable

 Tobias 1 points

the inner diameter is 4,8mm vor 5mm endstücke Lg TObi

 natenkw 10 points

Im sure it is 4mm

 bongsky007 92 points

This stinger is 5/16 or 4.7mm inner dia and paired with the unthreaded propeller drive. Replacement stinger drive for brushless Pursuit. Very good hardware and easy to adjust and install.

 natenkw 10 points

The pursuit has a 4mm prop shaft. Not a 3/16.
Get you facts strait.

 bongsky007 92 points

I already had 2 pursuits and all of them has a 4.7mm shaft. And for your info the flex cable is also 4.7 mm not a 4mm as stated by hobbyking. I uses Octura x440 3 blade prop w/ 4.7 dia.

 natenkw 10 points

Well the one I have has a 4mm propshaft and a 4mm flex also, so go figure again!

 bongsky007 92 points

I believe you my friend. maybe if u purchase it on tear 2009 below. Mine already had 4.7mm/3/16mm prop shaft which is I think much better because I have more choices of prop.

 natenkw 10 points

I agree. I wish mine was 3/16.

 JOAO 19 points

inner diameter is 3/16 shafts

 Dennis 5 points

What is the inner diameter
cual es el diametro

 JOAO 19 points

inner diameter is 3/16 , 4,75mm

 DeeJayKerem 154 points

How do you learn this? not writing here...

 JOAO 19 points

I have 2 and i use them with 3/16 shafts , 0.150 flex cable

 DeeJayKerem 154 points

Is this new item for Hobbyking???

 JOAO 19 points

Only the stinger is from Hobbyking ,the rest bought in the United States.i can email you some photos & details

 DeeJayKerem 154 points

Thank you. my mail add: dkerem*hotmail****

 Fabrice 20 points

hello les mecs, effectivement c'est pour du Octura. Juste un problè*me mon arbre de transmission octura n'est pas assez long ?!? !?! ...Que faire * enlever les bague en bronze et usiner la chaise ou usiner un autre arbre de transmission.? J'attend vos conseils avisé*. A pluch d'ours ! hello guys, this is actually for the Octura. Just one problem my driveshaft octura is not long enough?!? !?! What to do ... and remove the bronze ring and machining the chair or another machine shaft.? I await your advice notice. A Pluch bear!