CNC Water Cooled Motor Mount

 marvin8888 139 points

can be but its not that effective due to the holes bored for the motor shaft and its mounting screws, but the esc cooling system instead.

 Semih Burc 4 points

The center hole is 100 mm, I am using it with an outrunner brushless and works great.

 numse 154 points

I hope you mean 10 mm ? Best regards Henrik

 Dr.Danny 56 points

How do you pump water through the motor mount with outrunner motor?

 numse 154 points

The motor is a passiv component. The speed creates a preasure of water in the water intake, with will push the water around in the system. If it's a out or inrunner motor dosent mater. Besr regards Henrik

 Dr.Danny 56 points

Thanks numse, I was convinced till now that the water was actively pumped through the system by the inrunner.

 tayothin 89 points

I had produce it by myself no need to order more.

Thanks

 Patrick 9 points

must product lateral blanks with CTP or epoxy. there are 4 holes for M3 screws for fixing side

 Emil K 24 points

Ah now i see it's bult to fit different mount whole lenghts.

 Emil K 24 points

But still I would like to know the length ot that variable length hole So i know what motor that can mount on it.

 tayothin 89 points

I bougth from local shop

Thanks

 Micho69 272 points

380 size motor. beauty someone erased my post:)

 Micho69 272 points

Distance of mounting holes is 19 mm.
- for 380 motor /19 or 16 mm hole distance/ Hole size is not important but i thing M3 or M2,5.

 tayothin 89 points

both size