Aluminum Prop Spinner 58mm / 2.25inch diameter / 2 Blade

 Pushrod 585 points

If the hole in the spinner is the same size or smaller you should be ok, if its bigger you may have a problem.

 Matej 30 points

I have that spineer on OS 65AX, and hole in the backplate of that spinner in bigger. No worries, you just have to center the backplate, otherwise spinner will wobble around. I used narrow masking tape, and i carefuly made couple of turns around the shaft, so backplate fitted in snuggly. Oh, and I had to order new brass nut, becouse my engine has M8 thread on shaft, and that prop adapter that comes with spinner has M6 thread. Without that nut, you can't fit spinner on backplate.

 Pushrod 585 points

This is for normal prop and looks great with its mirror finish also very light and good quality.

 Mario 3 points

yes it for normal prop and looks great with a nice model.

 HappySundays 180 points

It turned out to be a 3.175mm shaft! Really HK? A 58mm spinner on a 1/8" shaft? Fortunately the spinner base takes a standard shaft adapter.

 JANTAR 18 points

Is it suitable for glow motors?

 Matej 30 points

Yes, you can fit it on glow engine, you just dont use that prop adapter that comes with the spinner, and you may have to order new top nut. That nut that comes with spinner has M6 thread on one side and M4 thread on the other. I had to order new brass nut that has M8 thread on one side (so it would fit the shaft on my engine) and M4 thread on the other.