USA warehouse now open.
Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!


Public Profile
Ramon
Customer Type: Platinum Member
Location: Zaandam, NETHERLANDS
My movies
Recent product discussions
Turnigy Accucel-6 50W 6A Balancer/Charger w/ accessories (EU Warehouse)
Why is this thing so ridiculously overpriced in the EU warehouse? it's almost twice as expensive as ...
Hobbyking Bonsai EPP Wing 600mm (ARF) (EU Warehouse)
Not a question but a tip: If the CG is good, this thing can fly with any setup. Running super fast w...
Turnigy 9XR Transmitter Mode 2 (No Module)
Is there any information as to if or when this baby hits the Netherlands or Euro stores? I'm itching...
HD1610-3400KV Indoor/Profile/F3P Outrunner Motor
I'm looking to use 4 on a ultralight quad with 5030 triblade props, any numbers on max thrust?...
Hobbyking i86L Multi-Rotor Control Board (Lite Edition)
Hey guys, i'm running a tiny Y6 config on this, but it seems like sometimes the controls twitch and ...
HobbyKing Red Brick 10A ESC
Is it possible that this ESC detects a really empty 3S when you hook it to a very very full 2S (8.41...
Recent discussion reply
Turnigy Accucel-6 50W 6A Balancer/Charger w/ accessories (EU Warehouse)
I ordered over $3k in materials here, but never saw a 200% increase, sorry but no, I'm not buying th...
Hobbyking Bonsai EPP Wing 600mm (ARF) (EU Warehouse)
I didn't get the e-mail notification, but now.. :P...
Turnigy 9XR Transmitter Mode 2 (No Module)
WD40, it will do miracles...
Hobbyking KK2.0 Multi-rotor LCD Flight Control Board
Check if your transmitter shows 100% right rudder and 0% throttle in the monitor, it might be trimme...
Hobbyking KK2.0 Multi-rotor LCD Flight Control Board
Did you hook the wires from the receiver to the board properly? It should not make a difference what...
Turnigy 1811 brushless Outrunner 2900kv
Thank you for uploading that, but do you also have a comparison between props (specifically the 3 bl...
Turnigy MAX80W 7A Lithium Polymer Battery Charger
Any power supply that can deliver 10 or 12 volts at 8 to 10 amps should be sufficient for this speci...
Hobbyking i86L Multi-Rotor Control Board (Lite Edition)
This board is powered by the ESC BEC, so if the esc can do 1S then yes....
Turnigy MAX80W 7A Lithium Polymer Battery Charger
You can go into the menu and change the voltage per cell to 3.1V, it will then automatically switch ...
Turnigy MAX80W 7A Lithium Polymer Battery Charger
Hi, it's got polarity protection, you might have killed the battery or your power supply, but yo...
Wiki-blog entries.

Share