Please confirm your location:


USA warehouse now open.
Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!


Public Profile
firatp
Customer Type: Platinum Member
Location: KADIKOY, TURKEY
My movies
Recent product discussions
Flat 3-Way Switch (Long) (2pcs)
Can I use this switch on turnigy x9?...
HobbyKing X-Car 13.5 Turn Sensored Brushless Motor (2592Kv)
What is the difference between censored motor and not censored motor? ...
Team Associated SC10.2 Factory Team (Kit)
What is censored motor?...
EagleTree Vector Flight Controller w/ OSD, GPS and PSU Sensor
Now, price has been adjusted and reduced to same level of other sellers.
...
Turnigy MG90S Digital Metal Gear Servo 1.8kg / 13.4g / 0.10sec
Hello, I lost the screw which is at top of the servo. Where can I get? Thanks ...
Mini OSD System w/GPS Module
Can anyone upload the manual? I have just order for my quad. Thanks ...
H35 Standoff Motor Mount
Is this ount good for 3542 motor. Thanks...
Turnigy 9X 9Ch Transmitter w/ Module & 8ch Receiver (Mode 2) (v2 Firmware)
Hi Guys, I am about to order this radio to use it with DL UHF. What type of battery should I order?...
HobbyKing® ™ DH-82 Tiger Moth 1250mm Balsa (ARF)
Can someone upload manuel? Thanks ...
Ryan ST-A Super Scale EP Composite w/Flaps 1112mm (ARF)
Can someone who bought this bird, upload the building manuel? Thanks ...
Recent discussion reply
FPV Fiberglass Pan-Tilt Camera Mount
You don't need to have a separate Tx/Rx. Just put 2 servos for pan and tilt, then connect those serv...
FPVRaptor Composite 1600mm (PNF)
Hi, I thing the motor will be not enough for me. I wil carry 5000mah and 1000mah batteries and all f...
FPV 12dBi 5.8GHz Antenna
Did anyone try? Really does it help to extend the range?...
HobbyKing™ Cell Checker with Low Voltage Alarm (2S-8S)
How can i set the voltage to 3.6V. My one alarms at 3,8 Thanks ...
Turnigy Aerodrive SK3 - 3536-1400kv Brushless Outrunner Motor
Right. A good replacement for NTM 3536 which has big vibrations. ...
TURNIGY Plush 60amp Speed Controller
Thanks, This is the answere I need.
It has done....
HK-500GT Metal Tail Holder (Align part # H50073)
Hi dudes, Does it fit to trex500?...
Wiki-blog entries.

Share