Please confirm your location:


USA warehouse now open.
Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!


Public Profile
fdamore
Customer Type: Platinum Member
Location: BURBANK, UNITED STATES
My movies
Recent product discussions
SkyZone 5.8G 500mW 8 Channel AV Transmitter FPV
Has anyone had trouble removing the antenna? Or di I just get luck. Mine wont unscrew. I bought cl...
DJI Naza-M Lite Multi-Rotor Flight Controller GPS Combo
****...
MultiWii PRO Flight Controller w/MTK GPS Module
Are the steps below (from manual) the only way to calibrate the ESC's? 1.setup all options in confi...
MultiWii PRO Flight Controller w/MTK GPS Module
Can't arm flight controller. Using Turnigy 9X Tx and Rx. Rx has been bound to Tx. Solid light on Tx...
MultiWii PRO Flight Controller w/MTK GPS Module
Is the board powered by any of the ESC connections to the board? Do I need to remove the center wire...
Hobbyking KK2.0 Multi-rotor LCD Flight Control Board
Does updating the KK board to a new firmware version wipeout the current configured settings?...
Hobbyking KK2.0 Multi-rotor LCD Flight Control Board
you can down load version 1.5 firmware from: ***********rcgroups****/forums/attachment.php?attachmen...
Turnigy Brushless ESC 85A w/ 5A SBEC
Can somone point out the link to the correct ESC programming card for this speed control?...
Recent discussion reply
MultiWii PRO Flight Controller w/MTK GPS Module
not yet...I finally got the controller to arm after adjusting the trim settings for throttle and ya...
MultiWii PRO Flight Controller w/MTK GPS Module
Thanks so much! It was the yaw and throttle settings....
MultiWii PRO Flight Controller w/MTK GPS Module
Meant to say solid light on Rx. ...
MultiWii PRO Flight Controller w/MTK GPS Module
Thanks...
Hobbyking KK2.0 Multi-rotor LCD Flight Control Board
If you are not getting any response at all from the gimbal servos, which should be connected to M7 a...
Hobbyking KK2.0 Multi-rotor LCD Flight Control Board
The controller is powered by the first ESC connected to the M1 port on the controller board. Also, ...
Wiki-blog entries.

Share