Please confirm your location:


USA warehouse now open.
Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!


Public Profile
StevenC
Customer Type: Platinum Member
Location: Karabar, AUSTRALIA
My movies
          
Recent product discussions
Turnigy Talon Tricopter (V1.0) Carbon Fiber Frame
Can anyone share their PIDs settings for Multiwii Pro w/ MTK GPS on this Talon tricopter please?...
Playful Puppy Robotic Kit with ATmega8 Control Board and IR Sensor
Here is another video of my puppy with some more changes...
Playful Puppy Robotic Kit with ATmega8 Control Board and IR Sensor
This is my puppy with some custom codes...
Playful Puppy Robotic Kit with ATmega8 Control Board and IR Sensor
Hey majik01, I received my puppy today yeaay! I finished building it and I write a code to make it w...
HobbyKing® Alien 560 Folding Quad-Copter Carbon Fiber Version (Kit)
This kit looks nice but it seems to offer very little protection to the top plate where all the expe...
Playful Puppy Robotic Kit with ATmega8 Control Board and IR Sensor
Here is a buddy code 5564BCA2-7436-4A79-98DB-EB9723CA6D8C...
Playful Puppy Robotic Kit with ATmega8 Control Board and IR Sensor
****...
Turnigy Multistar 3508-640Kv 14Pole Multi-Rotor Outrunner
Anyone using this motor with the Afro ESC?...
Turnigy Talon Tricopter (V1.0) Carbon Fiber Frame
Just a short video doing flips and rolls with a KK2 board with v1.6 rev2....
Turnigy H.A.L. (Heavy Aerial Lift) Hexcopter Frame 775mm
Are there any alternative landing gear replacement that will ffit the HAL hexacopter? I bought a M20...
Recent discussion reply
NTM Prop Drive 28 Series Accessory Pack
It's best to use M5 lock nuts instead of those spinners as the nuts won't loosen with angular accele...
FrSky 2.4G V8 Series 5db module Antenna
If you plan on using the stock Turnigy 9X module, this antenna won't fit directly because the stock ...
Hobbyking G-OSD 3 Mini OSD System w/GPS Module
Don't connect both the '5V from Fatshark' and '5V from ESC'. This means 5V 5V = 10V and you will p...
Hobbyking G-OSD 3 Mini OSD System w/GPS Module
No. You can't reset altitude with the stock firmware. Sorry...
FrSky D8R-XP 2.4Ghz Receiver (w/telemetry)
Power can go into any port (1-8). But if you are using it in a plane or helicopter, the ESC should g...
Afro ESC 30Amp Multi-rotor Motor Speed Controller (SimonK Firmware)
Load or no load, ESC will always become warm....
Hobbyking G-OSD 3 Mini OSD System w/GPS Module
Do you have another camera like a Gopro? When I first boughty GOSD, I had same problem as you, I cou...
Hobbyking G-OSD 3 Mini OSD System w/GPS Module
Try this. Make sure OSD is powered off first. Press and hold C while plugging battery in. Release C....
Hobbyking G-OSD 3 Mini OSD System w/GPS Module
Yes, it has two Voltage input, V1 and V2. It shows both of them. You can power the G-OSD through V2...
Afro ESC 30Amp Multi-rotor Motor Speed Controller (SimonK Firmware)
The FETs are very efficient and little energy is wasted as heat. I've been running these ESCs on my ...
Wiki-blog entries.

Share