Please confirm your location:


USA warehouse now open.
Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!


Public Profile
rromans
Customer Type: Platinum Member
Location: carleton place, CANADA
My movies
Recent product discussions
Turnigy 2815 EDF Outrunner 4800kv for 55/64mm
here is my problem...
Turnigy 2815 EDF Outrunner 4800kv for 55/64mm
here is my problem...
Quanum LEA-6H GPS with Compass and Pedestal Stand with Case
where is the Pedestal mount as a separate item to purchase...
NTM Prop Drive 42 Series Accessory Pack
the end of the prop hub seems to be off center. It has a bit of a wobble. It is not just the prop hu...
XT60 Panel Mounting Kit
Come on HK, the set screw holes have to be tapped at the factory. It is far too difficult to be done...
OrangeRx R110XL 2.4Ghz DSMX Satellite Receiver (long antenna version)
For some reason the DSM2 satellite Rx is hidden and NOT included with Orange 2.4g Spektrum group but...
OrangeRx R110X 2.4Ghz DSMX Satellite Receiver
For some reason the DSM2 satellite Rx is hidden and NOT included with Orange Spektrum group but you ...
C Bracket Pins (4Pcs/Bag) - 110BS, A2027, A2028, A2029, A2031, A2032, A2033 and A2035
are these also used in A2030? because I do not see any part listed under A2030...
1/4 - 20 x 2 inch (Wing Bolt) Nylon Screws (10pcs/bag)
I find these bolts are NOT 0.250 DIA across the thread. They are like 0.240 so it gives a loose fit....
NTM Prop Drive 13-12 3000KV / 28W
where do you get the prop adapter for this. either prop saver or adapter ...
Recent discussion reply
Turnigy 2815 EDF Outrunner 4800kv for 55/64mm
m3 is largest, other is 2.3mm and that would be too small.. ...
Turnigy 2815 EDF Outrunner 4800kv for 55/64mm
use 3m that fits the fan. I just used contact cement on the shaft where fan mounts and then tighten....
Turnigy 2815 EDF Outrunner 4800kv for 55/64mm
Ok m3 washer and the wheel collar might work.. Yes same here, unable to get fan on tight..I am going...
Turnigy 2815 EDF Outrunner 4800kv for 55/64mm
Yes same here, just noticed no circlips to stop outer rotor from coming away from rest of motor wind...
XT60 Panel Mounting Kit
Ok I tapped the holes and now the set screw works fine. Yes it is a little loose compared to self ta...
XT60 Panel Mounting Kit
OK thanks an opinion is good. unable to use thread lock because it will eat the plastic. I use paint...
XT60 Panel Mounting Kit
Sorry I do not agree. Yes I know how to do it but no, It is too difficult for the customer to do thi...
OrangeRx R110X 2.4Ghz DSMX Satellite Receiver
when you say it works, how do you know unless you disable the main antenna and see that the satellit...
FY-DoS Inertial Attitude Stabiliser with GPS (Multi-Rotor)
yes, I did it. I bought an airplane version from someone online and uploaded 2.3 firmware for quad a...
FY-DoS Inertial Attitude Stabiliser with GPS (Multi-Rotor)
yes you can after you change firmware to mulirotor version. Go to vendor's web site to download firm...
Wiki-blog entries.

Share