Location: UNITED STATES
HobbyKing RC Model HomePage RC Radio Control Help and Support RC Hobby Forum Contact our RC Hobby Support Staff About HobbyKing
RC Model Planes RC Model Cars RC Model Helicopters RC MultiRotor and Quadcopters RC Boats RC Electronics
AIRPLANES AIRPLANE ACCESSORIES POWER SYSTEMS RADIO SYSTEMS
TELEMETRY & FPV
 
 
 
 
 
CARS CAR ACCESSORIES POWER SYSTEMS RADIOS
 
 
BOATS BOAT ACCESSORIES POWER SYSTEMS RADIOS
HELICOPTERS HELI ACCESSORIES POWER SYSTEMS RADIOS
 
 
 
MULTIROTORS ACCESSORIES POWER SYSTEMS RADIOS
ELECTRONICS ELEC. ACCESSORIES
EMAIL  PASS 
TOTAL $0.00 QTY 
Planes & Parts
Helicopters & Parts
Multi-Rotors & Parts
Cars & Parts
Boats & Parts
Bikes & Parts
Scale R/C Tanks
FPV & Telemetry
Batteries & Accessories
Chargers & Accessories
Electric Motors
Speed Controllers
Robotics & DIY
Servos & Parts
Radios & Receivers
Gas/Glow Engines & parts
UBEC & Regulator
Power Systems
Hardware & accessories.
Tools
Clothing, Gift & Acc.
Sale/Liquidation

Language
Currency
USA warehouse now open.
Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!


Public Profile
Roy_T
Customer Type: Platinum Member
Location: #03-06, Hume Park 2, SINGAPORE
My movies
Recent product discussions
Carbon Fiber Sheet 1.0mm*300mm*150mm
Is this rigid (e.g. like a cardboard)? What is the actual weight?...
2.4Ghz SuperMicro Systems - Receiver and ESC All-in-one (5ch)
Has anyone successfully used this RX on a brushed motor setup with the Supermicro TX module TGY 9X? ...
EDF-55 Impeller (EP2245X6 Black)
What is the shaft size for this impeller?...
EDF55 Impeller for 55mm (8 Blade) system
What is the shaft size for this impeller?...
Turnigy Monster-2000 ESC programming card
Has anyone programmed the Turnigy 5A 1S Brushles ESC with this card? My programming card does not se...
FrSky V8FR-II 2.4Ghz 8CH Receiver (HV)
Hi,
Does anyone know what is the pin configuration of the V8FR?...
TURNIGY BESC Programming Card
How do i know if my BESC Programming card is working? I've connected a separate 6v power to the prog...
Turnigy 9X 9Ch Transmitter w/ Module & 8ch Receiver (Mode 2) (v2 Firmware)
Can anyone advise how i can bind the transmitter to receiver? The instructions given in the SkyRc si...
Recent discussion reply
Turnigy AAA LSD 900mah Low Self Discharge (ready to use)
You can charge it at 1C (battery gets warm). If you want long battery life, charging at 100-200mah....
USBasp AVR Programming Device for ATMEL proccessors
I'm using the following:
USBasp Windows driver from http ://****fischl.de/usbasp/
GUI Software...
USBasp AVR Programming Device for ATMEL proccessors
I'm fine running the following on Win7 32bit. Give it a go.

USBasp Windows driver from http :...
Turnigy nano-tech 450mAh 2S 65-130C Lipo Pack (E-flite Blade 130X)
Got to agree with mtuccio, i've used a 3S 20C 800mah Zippy & a 3S 45C TP 325mah on my Black & Decker...
HobbyKing AP03 4000kv Brushless Micro Motor (3.1g)
If you live in Europe, try **** micronradiocontrol. co .uk/prop_adapter.html...
GWS EDF Impeller for 30mm (EDF30) system
The fins are thin and can be easily be cut off using a pen knife....
ZIPPY Flightmax 700mAh 6.6V 5C LiFePo4 Reciever Pack
Have you tried plugging LiFe into the ESC? BEC output is usually 5V (or 6V max). Suspect either the ...
ZIPPY Flightmax 700mAh 6.6V 5C LiFePo4 Reciever Pack
Do note that since the LiFe pack has a lower terminal voltage (than regular LiPO), the voltage sag u...
iCharger 106B-plus 250W 6s Balance/Charger
Robert, by connecting the 1S cells (in parallel) using the wiring harness, they are already 'balanci...
Turnigy AA LSD 2200mah Low Self Discharge (ready to use)
The TGY9X can take a voltage close to 9v without problem (assume you're flying within a park). A...
Wiki-blog entries.
 

Share

Copyright Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved