USA warehouse now open.
Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Location: Nijverheidsweg 16B, NETHERLANDS
|Recent discussion reply|
|Openpilot CC3D Flight Controller With Cable Set Fully Authorized|
This board does indeed not have 10 degrees of freedom, only 6, so no mag or baro, and no gps support...
|2A Micro-Stepping Stepper Motor Driver A4988 ( Pololu Compatible )|
The ULN2003 is the driver chip that is commonly used with those 28BYJ-48 motors. You can drive thos...
|NTM Prop Drive 28-36 1000KV / 400W Brushless Motor|
indeed, the motor does not care at all about the voltage it is connected to. Except when it does...
|Turnigy Smart Retractable Landing Gear - Gear and Door Sequencer|
This does not look like a atmel package, I've never seen them in soic package. Could be a pic or a 8...
|Mini OSD System w/GPS Module|
better get the minim osd that can worp with apm protocol messages: you will get the autopilot to tel...
|Mini Indoor Plane 3 Channel 2.4ghz 392mm (RTF)|
There are indeed quite a few models that come with their own transmitter but will bind to the 9X (na...
|Walkera QR Ladybird V2 Ultra Micro Quadcopter RTF (Mode 2)|
Suspect, it looks like you did not like the answer, but the answer is right: It is very unlikely tha...
|Turnigy 3 Function 5 Amp Ubec Voltage Display Switch|
yes, there is a very good reason not to use a servo plug instead of the 2-pole jst plug: most batter...
|Turnigy 5014 530kv Brushless Multi-Rotor Motor|
yes, efficiency is low, but I think it can handle more than 150W. 15x20=300 after all. But low kV mo...
|Turnigy RotorStar Dual Power 15A Voltage Regulator|
yes, you can use it for a 6 servo plane, but you should choose another power option for two servos. ...