Things I wish HK would sell - 6

I wish HK will sell:

The full line of Frsky products, esp. all USB cables (FUC-2, FUC-3) so I can update DHT-U and Hub ...
Also all receivers (D8R-II plus, D8 R xp, ....

Hi. Try tu use D2826-6 2200kv ( http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=12919 ). I use that motor on my Floater and it flies very well

+1

I think that selling FPV parts without being obliged to buy the complet set ( TX Rx Cam ...) would be a good thing.The video-radio sets offered by HK are good stuff ,but If U want improoving your UHF link by buying a new 800 mW transmitter , U can't buy it at HK , U are obliged to buy at BEVRC forinstance , that's a pity..

Other topic : When you have to drive the throttle of a twinn engine on a small plane , a special mixer dedicated to this use could be very helpfull to common RC practice.
Recently I have used the V-Tail Mixer (HK ), to mix throttle channel out of receiver with an Auxiliary channel( 5)(it's the the servo time gap of each Ch that are mixed ), to trim the RPM gap between the two engines.
That's doing very well because it helps to keep the same Throttle Lever than for a single engine( piloting is more easy that way) and allows to trim ( or pilot ) the differencial RPM Right/Left as necessary to get the nice smooth twinn prop synchronizing song.
I experienced it with the HK contra rotative twin Brushless , and were very happy with the result.

Edited by NOBLER2 - 05/May/2012 at 9:11pm

3m-4m sailplanes