Location: UNITED STATES
HobbyKing RC Model HomePage RC Radio Control Help and Support RC Hobby Forum Contact our RC Hobby Support Staff About HobbyKing
RC Model Planes RC Model Cars RC Model Helicopters RC MultiRotor and Quadcopters RC Boats RC Electronics
AIRPLANES AIRPLANE ACCESSORIES POWER SYSTEMS RADIO SYSTEMS
TELEMETRY & FPV
 
 
 
 
 
CARS CAR ACCESSORIES POWER SYSTEMS RADIOS
 
 
BOATS BOAT ACCESSORIES POWER SYSTEMS RADIOS
HELICOPTERS HELI ACCESSORIES POWER SYSTEMS RADIOS
 
 
 
MULTIROTORS ACCESSORIES POWER SYSTEMS RADIOS
ELECTRONICS ELEC. ACCESSORIES
EMAIL  PASS 
TOTAL $0.00 QTY 0
Planes & Parts
Helicopters & Parts
Multi-Rotors & Parts
Cars & Parts
Boats & Parts
Bikes & Parts
Scale R/C Tanks
FPV & Telemetry
Batteries & Accessories
Chargers & Accessories
Electric Motors
Speed Controllers
Robotics & DIY
Servos & Parts
Radios & Receivers
Gas/Glow Engines & parts
UBEC & Regulator
Power Systems
Hardware & accessories.
Tools
Clothing, Gift & Acc.
Sale/Liquidation

Language
Currency
USA warehouse now open.
Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
  Item found in the following categories;
> Boats & Parts > Gas/Glow Boats

  RATED:

Hydro Formula 1200GP 26CC Hydroplane Racing Boat 1200mm (AUS Warehouse)

Hydro Formula 1200GP 26CC Hydroplane Racing Boat 1200mm (AUS Warehouse)
Hydro Formula 1200GP 26CC Hydroplane Racing Boat 1200mm (AUS Warehouse)


The Hydro Formula Power Boat is a large scale 26CC gas powered hyrdoplane racing boat that not only looks the part, it has the performance to back it up. With its vibrant, beautifully finished paint scheme and fiberglass hull, this is one boat that is sure to turn heads!

This high speed race boat is very well thought out with its easily removable access hatch featuring alloy quick-release fasteners, externally mounted engine kill-switch, rubber dampened engine mounts, pre-installed water cooling system and vented canopy to keep the inside of the hull cool.

Featuring a powerful pre-installed 26CC gas engine, CNC alloy hardware, and high torque steering/throttle servos, this boat is almost ready to run. You will just need to add your own 2ch radio system, fill up the fuel tank and your ready to leave the competition in your wake!

• Powerful 26CC Gas Engine
• Rubber Dampened Engine Mounts
• CNC Alloy Rudder, Strut Mount and Propeller
• High Torque Steering/Throttle Servos
• Quick-Release Access Hatch
• Externally Mounted Engine Kill-Switch
• Pre-Installed Water Cooling System
• Vented Canopy

Specs:
Length: 1200mm
Beam: 600mm
Height: 270mm
Hull material: Fiberglass composite
Engine: 26cc gas


PRODUCT ID: 151000010

This product available from a warehouse near you!

14664g Back warehouse: 0 -2 $393.95
Email Buddy Issue Price War
battery
  • A123-6.6VB 2300mAh 2s1P Receiver Pack

    Combo Price: $16.69   IN STOCK



acc.
  • HK-300 3 Channel 2.4ghz FHSS Ground Radio

    Combo Price: $19.76   IN STOCK

  • Hobby King GT-2 2.4Ghz 2Ch Tx & Rx

    Combo Price: $15.95   IN STOCK



Further discounts available for registered & logged-in customers.
STOCK ARRIVAL ALERT

Enter your email address to get an email the second new stock arrives.
Estimated factory delivery date;
 Customer rated 0 crown   
 
Total of 6 discussions.
pauly64  6 points - 12/9/2012
 
someone run this thing yet they sold a few want to know how about running issues
plasticbaldy  376 points - 9/12/2012
 
Has anybody got something like this with a dead motor for sale ?
KaosKane  1442 points - 6/12/2012
 
I am learning about boats so please ... what r the two clear hoses connected to rudder for and will the exhaust spay hot gas on these hoses (in pic 9) Thanks in advance
 T6Texanaus 301 points
That's all part of the water cooling system. small holes in the rudder pick up water and use the forward motion of the boat to pressure feed it throughout the boat providing cooling to the exhaust in two places and the motor head as depicted in pics 10 and 11 before being dumped overboard through the outlet in pic 4 the silver dot just forward and above the word GASOLINE. As for exhaust gases those lines could be shortened a small amount to provide clearance but don't kink them off but as they appear to be sillicone, heat is not an issue.
BEST ANSWER CREDIT AWARDED
 T6Texanaus 301 points
Glad I could Help
 georgep 6 points
Very well explained T6Texan. the exhaust gasses shouldn't be hot enough to affect the silicone hoses. If they are ,then it is running way too lean.
alberto  8 points - 6/10/2012
 
When in euro warehouse!????
pauly64  6 points - 6/5/2012
 
whers the turn fin its not going to turn too good without it
 Bullet-Bait 71 points
The turn fin or rudder is the blue anodised piece (to the right of the prop) at the back of the boat. (PIC NO.9)
 pauly64 6 points
not the rudder the turn fin just cause you dont know the difference having to install it after the build would wreck the paintwork
 Bullet-Bait 71 points
Well Excuse me you're referring to skid fins. Sorry I didn't understand your terminology. Unless you are actually planning to race it would be useless having one of these on. A Hydro is Designed and Built to do 1 Thing and that's Race around an Oval Track As Fast As Possible in 1 direction. If you are going to race then it wouldn't be hard to add one without wrecking the paint work, That's if you have any clue to what you are doing!!!
iuli_b  3 points - 6/4/2012
 
Nice product.When is arrived in Europe?
 palton 19 points
i agree, I would like to see this one in European warehouse. This is a must have....
BEST ANSWER CREDIT AWARDED
 Gordo 26 points
I would like to see this in the international warehouse but shipping might be a shocker [CANADA]
 Heli_King 228 points
This might be a stupid question but since the canopy is vented, does it come with a bilge pump?
 iuli_b 3 points
It is normal to be vented because the engine needs air to run but the water it's not comming inside the hull.....maybe just a little bit which is insignificant.The model is not come with a bilge pump but if you want you can mount very easy one.You can find a good bilge pump to boats&parts/gas/glow boats spare parts also can be used as cooling water pump when engine is running at low rpm.
 Heli_King 228 points
I see what your saying, I think it would be a necessity to be honest as its likely you could run this boat for a long time. I think the intake of water would be greater than you think and this might compromise the boat if you dont have a bilge pump fitted, Besides like you mentioned about engine cooling, it could only be a good idea to fit one.
 toni 2 points
what speeds is it roughly capable of?
 X-SPORT 4 points
I wants spare Hydro Formula parts Tuned Pipe. HK have goods??????????? THX
Customer Reviews
There are currently no reviews for this product.
Be the first to review it by clicking the link above!
 
Aff. Link

Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved