USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Designed specifically for the Walkera QR Ladybird/Genius CP/Mini CP.
A direct replacement for Walkera WKLIP230.
More than just a fancy name. TURNIGY nano-tech lithium polymer batteries are built with an LiCo nano-technology substrate complex greatly improving power transfer making the oxidation/reduction reaction more efficient, this helps electrons pass more freely from anode to cathode with less internal impedance. In short; less voltage sag and a higher discharge rate than a similar density lithium polymer (non nano-tech) battery. For those that love graphs, it means a straighter, longer curve. For pilots it spells stronger throttle punches and unreal straight-up performance. Excellent news for 3D pilots!
Unfortunately with other big brands; numbers, ratings and graphs can be fudged. Rest assured, TURNIGY nano-techs are the real deal, delivering unparalleled performance!
*The nano-core technology in lithium ion batteries is the application of nanometer conductive additives.
1) The nanometer conductive additives form ultrastrong electron-conducting networks in the electrodes which can increase electronic conductivity. 2) These additives create a superstrong ability for imbibition in the carrier liquid to supply more ion channels. This improves the ability of ion transmission and ion diffusion. Through improving electronic conductivity and ion transmission, the impedance is reduced and the polarization of high rate discharge decreases greatly. Advantages over traditional Lipo batteries; -Power density reaches 7.5 kw/kg. -Less Voltage sag during high rate discharge, giving more power under load. -Internal impedance can reach as low as 1.2mΩ compared to that of 3mΩ of a standard Lipoly. -Greater thermal control, pack usually doesnt exceed 60degC -Thickness swelling during heavy load doesnt exceed 5%, compared to 15% of a normal Lipoly during heavy load. -Higher capacity during heavy discharge. More than 90% at 100% C rate. -Fast charge capable, up to 15C on some batteries. -Longer Cycle Life, almost double that of standard lipoly technology.
I just received two of these batteries for my Skyartec Wasp Nano CP helicopter and they fit excellent to the battery tray (almost the same size). The heli has more power now than the stock Skyartec batteries, it flies better and the flight time has increased about 2 minutes . Is an excellent choice to all who are searching more power for that heli. Although the working temperature of heli has decreased. Thank you HOBBYKING, good work.
I love these batteries. I have two Super Cp's running mini cp motors. I also have a mini cp. These batteries have that extra umph you NEED to get lift at key moments of flight. When motors get hot they draw more power, these batteries have the needed juice!
WORKS WITH:
MINI CP
SUPER CP
SHOULD WORK WITH:
Genius CP V1/V2
LADYBIRD
I cannot comment about the life cycle, but so far so good. It couldn't be any worse than the stock walkera batteries, I have gone through a ton of them. Hobby king is has a warehouse in Washington state, I got my batteries within days. I bought 10 of them. 5 stars IMO.
Oh :) sorry misunderstood the question.dont know. But i do need some connectors too. But ive looked and it seems HK does not have any . But if you find some please let me know. But if I do, I shall post here. Thanks
What I was thinking of doing, was make a cutout of thin flat plastic. Cut with my dremel tool a shape of the lipo connector, and use the pins from the red JST connector, and solder my wireing. Then hot glue theem behind the cutout, so I can just plug in my lipo into the cutout hole without the risk of .pluging lipo incorrectly. Hope this helps.
This battery is an awesome replacement and upgrade from the stock "Walkera QR Ladybird" Battery. Batteries arrived ready to use... didn't need to switch polarity on the wires. I get 7min 20 sec flight times (mild acro) with these batteries in my Ladybird.
Be aware because Walkera has other polarity than other MAnufacturers.
Howeber you can swich the wires around inside the plastic Part of the Plug to make them work.
Hope this helps
Is ther allso a replacement for the Lipo TRA6337? This is the Lipo for the Traxxas DR-1, a koaxial helicopter. This Lipo has 450mAh, the cable is in the middle and the size is very similar.
These batteries fit the hubsan X4 quad copter really well and they are loads better than the battery that comes with it,you will get 20 more MAH and a lot better C rating,as the batts that comes with the X4 are only 15c if that. So you will really notice the difference with these batteries than the stock ones as i did. *-)
I doubt it. I have the champ and a ladybird quad. This batt works well with ladybird, but for champ you need a narrower battery. The width of this batt will not fit the cavity of the champ. Unless you are planing to shave of some foam from your champ. I hope this helps.
I guess if you shave some foam, It should work, as the voltage rating for this battery and the one for the champ is the same. Also this battery with give you a very long flight time with the champ. Really LONG.
Is this a Losi Micro plug? I went to the LHS and found a Losi Micro plug that looks very similar, now I'm j ust waiting for my LadyBird to get here so I can verify.
My Bird arrived today. I can confirm this is a Losi Micro Plug but with Reverse Polarity which is the way the LadyBird is designed. So you can buy Product:XT60-MINI and switch the Polarity of Leads. Or do the same if you buy Losi Plugs from LHS. Always use Multimeter just to be sure.
Hey HK, slap two of those together and solder a UMX connector, and that would seem to be the perfect size for the 2S UMX airplanes. Your 180mah are great, but a weebit more juice would be nice. That or a 300mah UMX battery please?
Anyone who uses walkera plugs, just cut em off and use micro-deans, what I do, plus I made a pigtail connector for my charger with a micro-deans connector which when mated with another micro-deans fits onto a JST connector perfectly :P (Just be careful of polerization!)
I have a e-flight f-series these battries fit perfectly.and get more flight time.
Customer Reviews
Overall Rating
rcmodelreviews.
244 likes
Value
Quality
Like it?
These are brilliant batteries for the Ladybird. They give longer flight times and more "punch", especially towards the end of the flight. Brilliant value get at least four and you'll never have to stop flying ;-)
These are great little batteries. I get at least 2 minutes more than the standard battery supplied with my ladybird. The size is slightly thicker than the standard ladybird one but that is good as it holds in the battery cradle better.
No comments. Reply..
Overall Rating
xxrexxmyxx
14 likes
Value
Quality
Like it?
Salut,
À ce prix, il ne faut pas hésiter...
J'en ai donc pris 4 pour ma Ladybird : impeccable.
On note effectivement un gain de pêche et de durée de vol de l'ordre de 10/15pcnt (à vue de nez...).
Je n'ai mis que 4 étoiles dans la case Quality car les connecteurs ne sont pas parfaitement adaptés à ceux de Walkera, ils forcent pas mal côté quad et flottent côté chargeur. Mais ce n'est pas un motif nécessaire pour se passer de ces accus.
D'autant qu'ils peuvent aussi constituer de très efficaces accus de réception 1S pour alimenter 1 récepteur et 2 ou 3 servos qui le supportent.
Rx
No comments. Reply..
Overall Rating
Jan Ove
2 likes
Value
Quality
Like it?
Cheap batteries that can be replaced with the original battery, but give me only approx. 2-3 minutes of flight time.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg){kind=small}
.jpg){kind=small}
.jpg){kind=small}
