Please confirm your location:


USA warehouse now open.
Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
  Item found in the following categories;
> Electric Motors > TURNIGY
> Electric Motors > TURNIGY EasyMatch
> Electric Motors > Outrunners by size > 35 to 44mm

  RATED:

Turnigy G10 Brushless Outrunner 810kv (.10 Glow) (US Warehouse)

Turnigy G10 Brushless Outrunner 810kv (.10 Glow)  (US Warehouse)
Turnigy G10 Brushless Outrunner 810kv (.10 Glow)  (US Warehouse)

Designed to be a direct swap out for your .10 size glow engine. The Turnigy EasyMatch G10 brushless outrunner will provide longer run times and more power and with its high efficiency. A quality motor, built specifically for planes designed to fly with a .10 size glow engine.

Spec.
Battery: 2~4 Cell /7.4~14.8V
RPM: 810kv
Max current: 42A
No load current: 11V/1.2A
Internal resistance: 0.035 ohm
Weight: 140g  (not including connectors)
Diameter of shaft: 5mm
Dimensions: 35x50mm

Test Data:

11.1v - 13X4 Prop - 21A - 1570g Thrust
11.1v - 12X6 Prop - 26A - 1590g Thrust
14.8v - 10X5 Prop - 25A - 1650g Thrust

 

 

 


PRODUCT ID: G10-810

Kv(rpm/v) 810
Weight (g) 140
Max Current(A) 42
Resistance(mh) 35
Max Voltage(V) 15
Power(W) 375
Shaft A (mm) 5
Length B (mm) 50
Diameter C (mm) 35
Can Length (mm) 25
Total Length E (mm) 67
Update/Add my own data
Customer Data

Weight: 225g Quantity: 
International Warehouse In Stock View Item
stock
3
Price$27.15


Related Products
Customer Also Bought
Further discounts available for registered & logged-in customers.
 Customer rated
55
crowns
  
 
Total of 9 discussions.
Major  7 points - 2/17/2014
 
I ordered a pair of these and neither had back plate screws. The ones recommended by HK did not fit because the motor holes were not tapped properly. I will use a 4-40 tap and screws to hopefully solve this problem. It is a good thing they were not too expensive. You take your chances sometime here.
ERNEST V  1 points - 11/2/2013
 
WHAT PROP ADAPTER DO I NEED TO USE THIS MOTOR AND THE FOUR BLADE CORSAIR PROP
Ian  25 points - 11/1/2013
 
I tried forcing the collet down onto the shaft yet it still just spins freely. How do I make it so the propeller is properly attached to the shaft and won't slide up and off the shaft?
Coach D  3 points - 10/11/2013
 
What is the recommended Nano-Tech Lipo, AND correct ESC for the motor? Will be on a trainer, 36" wingspan, 3 LBS total flying weight. Sorry, not into the metric system! Is this even a good match for this plane. It had a .10 Glow engine, so I assume this will be fine due to its description. Thanks! "D"
Michael  5 points - 9/3/2013
 
Hello looking for a direct replacement for an older E-flight apprentice. Will this work? Thanks Mike
Customer Reviews
Overall Rating
LarrySee
92 likes
Value
Quality
Like it?
The G10 motor is underrated at 375 watts. Installed in a 3DHS 42" AJ Slick, data from the ICE 50 ESC shows the following results using a Turnigy Nano-Tech 4S 2650 mah 25-50C battery and 13 X 6.5 prop during the first full throttle event: Volts = 14.3, Current 40.0 Amps, Watts = 572. During the 6.5 minute flight the ESC temperature never reached above 55 degree celceius (131F). The flight performance was startling with unlimited vertical and high speed level flight. The front of the motor had unobstructed air flow and judicious throttle management was used.


No comments. Reply..

Overall Rating
Virgil
5 likes
Value
Quality
Like it?
I put this 10 in my Fun Cub and 12X6 prop using 2200 3cell battery,40 ESC and have plenty of thrust to make it go straight up. You can reverse the shaft on these and my one crash hit right on shaft adaptor and the shaft didn't bend. I can say for the money this motor is pretty good quality fairly quiet and so far no problems. I'm going to try a 13X4 prop with it for my Fun Cub and see how that works as it is a little less amps and almost as much thrust. Flight times are a good nine minutes with safe time left doing aerobatics and tuch and go's. Don't think you can go wrong and would reccomend this motor.


No comments. Reply..

Overall Rating
Damith
1 likes
Value
Quality
Like it?
Awesome for 2000g quadcopters!! check out the video: http://www.youtube.com/watch?v=kzqyP8ZPR70


No comments. Reply..

Overall Rating
Major
6 likes
Value
Quality
Like it?
Install yesterday and was amazed with the power which is very similar to my Neo 10, at half the cost. Will be buying more of these soon.


No comments. Reply..

Overall Rating
Major
6 likes
Value
Quality
Like it?
Used this motor for the first time today in myT28. This is a good motor with adequate power but less than my Neo 10. Nevertheless, I am pleased with this one compared to the Turnigy 2836 I ordered, which very very disappointing.


No comments. Reply..

.....click here to see all reviews
Aff. Link