USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
The Turnigy TrackStar 1/10th scale 100amp car ESC is the latest addition to Hobby Kings Sensored Car ESC range.
Using a Fast Silicon Labs MCU and high quality On-Semiconductor MOSFETs the TrackStar 100A ESC sets a new standard in high quality yet affordable car ESCs. With Intelligent MCU logic the TrackStar series ESCs allow extremely precise start up control and positioning feed back from the motor. This translates in to very smooth start up and acceleration.
Timing Indicator LED. To conform with ROAR's Sportsman Class racing rules and assist race organizers monitor driver compliance in non-timing modified race classes the TrackStar 1/10th ESC includes a timing mode indicator LED. At all times when the ESC is powered on and dynamic motor timing is set to a value greater than zero the white LED will illuminate indicating that the timing mode has been modified.
The Turnigy TrackStar 100A ESC also boasts a host of programing options not usually found in a 1/10th scale ESC at this price and can be programmed with ease via the Turnigy TrackStar programing card (sold separately) The Turnigy TrackStar 100A ESC also included 3 x 12AWG Motor wires and 2 x 12AWG power input wires.
Specification: Cont. Current: 100A Burst Current: 200A Car Size: 1/10th Battery: 2-3 Cell Lipo L-BEC: 5.0V / 2A Output Motor Type: Sensored or Sensorless Brushless Size: 40.5 x 37.5 x 24mm Weight: 45g Battery Plug: Required On/Off Switch: Yes Reverse: Yes Thermal Overload Protection: Yes Battery Terminals: 12AWG size Motor Terminals: 12AWG size
Programming Options (Via Optional programming card) Brake/Reverse type Brake amount Reverse amount Punch Control Drag Brake Throttle Dead Band Voltage Cut off Motor Timing
PRODUCT ID: TTS-100A
180g
2
$59.80
motor
Turnigy TrackStar 4168 2650KV 1/8th Brushless Motor (AUS Warehouse)
Which programming card works? I bought the 100a card with the display and the esc just displays read and continues beeping at me when connected to the card? Help
This is the card I got
http://www.hobbyking.com/hobbyking/store/uh_vie wItem.asp?idProduct=32128
you can simply program the esc with the remote, yes it takes longer, but i think its more in depth of what the settings do.
i always just used the remote and was great!.
To do it, hold the trigger down, turn on the esc, keep holding till it beeps, keep holding till the second beep untill it sounds like beep..beep..beep..beep, blah blah so on, it's all in the instructions anyway.
I know programming via transmitter supposed to work but mine's dead so being replaced. Good support from HK though! Not related to the ESC fault but I was using the wrong program card the HK one will not work with this ESC (I know seems obvious now)
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg)
.jpg&width=48)
.jpg&width=48)
