Large Scale 3D Yak54 30cc build

Hey ppl i have this modell at home http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=17568

PRODUCT ID: GLYak54-30cc

Have any1 of you built 1 and what servos did you use for it. Any problems with build and other tips and trix for the best possible experinse.

Edited by Heki78 - 29/Jun/2012 at 4:54pm

hi people, i am doing a peak models yak with dle 30 motor and and the cannister goes inside the fus, the conern i have is that the pipe passes just an inch below the fuel tank with just 3mm ply seperating the hot pipe and gas tank..... will the heat from the exhaust go up to the tank and cause a problem?
if its any use heki78 i am finishing a peak models yak 54 using 13kg hitec servos all round and 3300mah nimh battery with dle 30cc and canister pipe. no finished yet but needed to replace my slipstream sbach as 2.5 meter long model was too big to transport and took up too much room in my 1 bed apartment...my wife said its me or the plane.

hi, thanks for the link, seems he has the petrol tank just above the exhaust, i think that i may try and make up a heat shield of some sort and hope for the best.