setting up tricks tips etc

This is my setup.
I asked hobby king personel what to order and got a bit of a longer list but these where the parts i used.:


Talon Quadcopter
Board
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=19534
3 x BEC Eliminator
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=21496
Male to Male
http://www.hobbyking.com/hobbyking/store/__21758__10CM_Male_to_Male_Servo_Lead_JR_26AWG_10pcs_set_.html
Battery
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=7635
12awg wire
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=9673
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=9674
4mm bullet with covers
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=9283
2 x 3.5mm
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=68
Shrink Wrap
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=3833
4x ESC
http://www.hobbyking.com/hobbyking/store/__2161__TURNIGY_Plush_12amp_2A_BEC_BESC.html
4 x Motor
http://www.hobbyking.com/hobbyking/store/__8617__Turnigy_2730_Brushless_Motor_1300kv.html
2 x Prop
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=11331



the esc im using:

http://www.hobbyking.com/hobbyking/store/__2161__TURNIGY_Plush_12amp_2A_BEC_BESC.html

I put the throttle stick up to arm it. get it in program mode i mean.


I think ill order some lock tie and some locknuts I've allready had some nuts vibrate loose
And some of these :
http://www.hobbyking.com/hobbyking/store/__6203__Grub_Screw_set_b_M3x3_10_Pack_b_.html
If they would fit the engine, but i think the ones in it are not m3.. ?


Edited by Erikcramer - 06/May/2012 at 9:00pm

Here is the link to the KK manual:

rcexplorer.se/page14/kkguide/kkguide/quad.html

It is a lot easier to follow that the HK manual.

Here is another useful link:

http://www.kkmulticopter.com/

Edited by Sooty - 07/May/2012 at 12:53pm

Use the collet mount system. You have to buy a pkt of the size that fits your shaft and they clamp on with a grub screw. (Ouch!)
Don't use the HK prop-savers with the rubber ring retainers as the rubber rings break overnight all on their own and you do not want that happening while flying. Good idea for winged aircraft but not for quads.

Edited by Sooty - 08/May/2012 at 12:40pm

Originally posted by Erikcramer Is there a up and down on the props ?

Yes.

Fred

Does any one have any recommendations on the prop holders that are on stock....

For this motor with 3.1 mm shaft.
and the prop shaft is 4mm