canary glider

Message Topic Search Topic Options Post Reply Create New Topic Printable Version

the angle of incidence , as built is wrong , I have had to pack up the leading edge of the masin wing by about 4mm to get it to glide . I will fabricate something more aesthetically pleasing than the temp measure

( cut up ice cream carton ). probably the the best thing is to check before glueing in the carbon boom and ply former.

Managed to get it all working with the servo arms out side the fuse just below the L/E of the main wing. works fine. Also I have the controls all on the r h stick , seems easier to control .(ie elevator =elevator, aelerons =rudder ). 

Edited by hairykarts - 21/May/2012 at 8:29am

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version
hairykarts Members Profile Send Private Message Find Members Posts Add to Buddy List Platinum (NZ) USERID: 424820 Hobbyking Addict Joined: 24/May/2010 Location: auk nz Online Status: Offline Posts: 455	Quote Reply Posted: 21/May/2012 at 8:27am
	the angle of incidence , as built is wrong , I have had to pack up the leading edge of the masin wing by about 4mm to get it to glide . I will fabricate something more aesthetically pleasing than the temp measure ( cut up ice cream carton ). probably the the best thing is to check before glueing in the carbon boom and ply former. Managed to get it all working with the servo arms out side the fuse just below the L/E of the main wing. works fine. Also I have the controls all on the r h stick , seems easier to control .(ie elevator =elevator, aelerons =rudder ). Edited by hairykarts - 21/May/2012 at 8:29am
	I must remember .... when inverted .... down is up and up is down .