Turnigy VBar 600 Phasing Issue

Message Topic Search Topic Options Post Reply Create New Topic Printable Version

Hey there, I got my new VBar 600 installed and was going through the set up with no issues until I started adjusting the phasing for my 5 blade head.  Once I adjusted the phasing to ANYTHING other than zero degrees, my swash plate moves unevenly in collective.  The aileron and elevator channels seem fine but the pitch channel (collective) now moves in a forward tilt when I move the throttle stick up (I'm running a CopterX 450).  If I set the phasing back to zero, it works good with the swash being flat with throttle stick input.  Any ideas?

Thanks

Darren

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version
Nerrad Members Profile Send Private Message Find Members Posts Add to Buddy List Platinum (CA) USERID: 79708 Newbie Joined: 07/May/2010 Online Status: Offline Posts: 1	Quote Reply Topic: Turnigy VBar 600 Phasing Issue Posted: 10/Sep/2010 at 7:01am
	Hey there, I got my new VBar 600 installed and was going through the set up with no issues until I started adjusting the phasing for my 5 blade head. Once I adjusted the phasing to ANYTHING other than zero degrees, my swash plate moves unevenly in collective. The aileron and elevator channels seem fine but the pitch channel (collective) now moves in a forward tilt when I move the throttle stick up (I'm running a CopterX 450). If I set the phasing back to zero, it works good with the swash being flat with throttle stick input. Any ideas? Thanks Darren