HobbyKing Forums
Forum Home Forum Home > Product Specific > Transmitters and Receivers
  New Posts New Posts RSS Feed: Turnigy 9x - Flaps?
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

Turnigy 9x - Flaps?

 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
CptYellow View Drop Down
Platinum  (CA)
USERID: 505162
Newbie
Newbie


Joined: 04/Jun/2010
Online Status: Offline
Posts: 3
  Quote CptYellow Quote  Post ReplyReply Direct Link To This Post Topic: Turnigy 9x - Flaps?
    Posted: 12/Aug/2010 at 8:16am
I have a Turnigy 9x V2 with the Turnigy 2.4ghz module and HK-T6A V2 receiver and am trying to set up flaps.  I am farely new at this so please be patient.  The problem is that the only way I can get the flaps to work (I'm using two dedicated flap servos, one for each wing, connected through a Y connector to channel 6) is to turn on "Airbrake".  Now this works fine except that the flaps only have 1 stage under this setting, and the 3 pos switch operates in an OFF - ON - OFF configuration.  I would like to get the flaps working in a 2 stage setup such as off - half - full.  Any Ideas?

Edited by CptYellow - 13/Aug/2010 at 7:19am
Back to Top
RCER88 View Drop Down
Platinum  (US)
USERID: 88368
Hobbyking Addict
Hobbyking Addict


Joined: 28/May/2009
Online Status: Offline
Posts: 425
  Quote RCER88 Quote  Post ReplyReply Direct Link To This Post Posted: 18/Aug/2010 at 12:36pm
Set the flaps up with the knob. Then you have fully adjustable flaps. That is how I did my Corsair. It is easy to do just read the instructions. Far better that way.
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.54
Copyright ©2001-2008 Web Wiz

This page was generated in 0.141 seconds.